FERM TSM1033 [13/28] Environment
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

FERM TSM1033 [13/28] Environment

FERM TSM1033 [13/28] Environment
13
Transporting the bench saw
Before transporting the bench saw, the following
steps must be carried out:
•
Pull the mains plug
•
Turn the hand-wheel 5 (Fig. A) in anticlockwise
direction, lower the blade as much as possible
•
Remove all accessories that cannot be
mounted firmly to the power tool
If possible, place unused saw blades in an
enclosed container for transport
•
Slide the saw-table extension 9 completely
inward and turn the knob (Fig F-3) to lock it
•
Wind the mains cable and bind it
•
For lifting or transport, carry the main table 2
(Fig.A)
The bench saw should always be carried by
two persons in order to avoid back injuries.
Malfunctions
In the case that the machine is not functioning
properly, we give a number of possible causes
and appropriate solutions below.
1. The motor does not start
•
The plug is not in the mains.
•
The cable has been interrupted.
•
The carbon brushes are worn out. Replace the
carbon brushes or consult your dealer.
2. The workpieces is jamming against the
riving knife during processing
•
The saw blade must be aligned (Fig. E).
3. The saw cut is not smooth (frayed)
•
The saw blade must be sharpened.
•
The saw blade has been assembled back-to-
front.
•
The saw blade has become coated with resin
or sawdust.
•
The saw blade is not suitable for this process.
4. The workpiece is touching the back of the
saw blade and is jumping out
•
The riving knife must be aligned (Fig. E).
•
The fence is not being used.
•
The saw blade is thicker than the riving knife or
the riving knife is not being used
•
The saw blade must be sharpened.
•
The workpiece has not been kept in its place
until after sawing.
•
The tension button of the cross-cut fence is
loose.
5. The height and/or mitre handle is blocked
•
Sawdust and dust must be removed.
6. The motor has difficulty reaching the
maximum number of revolutions
•
The extension cable is too thin and/or too long.
•
The mains voltage is lower than 230-240 V.
7. The machine is vibrating
•
The machine has not been fastened onto the
workbench.
•
The frame is not level with the floor.
•
The saw blade has been damaged.
8. The electromotor runs unevenly
•
The carbon brushes are worn out. Replace the
carbon brushes or consult your dealer.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the motor. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact your local Ferm dealer. In the back
of this manual you find an exploded view showing
the parts that can be ordered.
ENVIRONMENT
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
EN

Содержание

Похожие устройства

Скачать