KRAFT KF-FDM454D901W [20/29] Salt rinse aid detergent
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

KRAFT KF-FDM454D901W [20/29] Salt rinse aid detergent

KRAFT KF-FDM454D901W [20/29] Salt rinse aid detergent
ПОСУДОМОЕЧНАЯ МАШИНА
DISHWASHER
ПОСУДОМОЕЧНАЯ МАШИНА
DISHWASHER
РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ
38 39
SALT, RINSE AID, DETERGENT
1. Water Softener
If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance
is equipped with a special softener that uses a salt container specifically designed to eliminate lime
and minerals from the water. The water softener is designed to remove minerals and salts from
the water, which would have a detrimental or adverse effect on the operation of the appliance. The
more minerals there are, the harder your water is. The water softener must be set manually, using
the water hardness dial. Your local Water Authority can advise you on the hardness of the water in
your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the
hardness of the water used. This is intended to optimize and customize the level of salt consumption.
Please follow the steps below for adjustment in salt consumption:
1. Open the door and switch on the appliance.
2. Press the Program button for more than 5 seconds to start the water softener set model within
60 seconds after the appliance was switched on.
3. Press the Program button to select the proper set according to your local environment, the
sets will change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set-up model.
WATER HARDNESS
Water softener
level
Salt
consumption
(gram/cycle)
German
°dH
French
°fH
British
°Clarke
Mmol/l
0-5 0-9 0-6 0-0,94 H1 0
6-11 10-20 7-14 1,0-2,0 H2 9
12-17 21-30 15-21 2,1-3,0 H3 12
18-22 31-40 22-28 3,1-4,0 H4 20
23-34 41-60 29-41 4,1-6,0 H5 30
35-55 61-98 43-69 6,1-9,8 H6 60
1°dH = 1.25°Clarke = 1.78 °fH = 0.178mmol/l
The manufactory setting: H3. Contact your local water board for information on the hardness
of your water supply.
Filling the water softener tank
Always use salt intended for dishwasher use. The salt container is located beneath the lower
basket and should be filled as explained in the following. Please follow the steps below for adding
dishwasher salt:
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour in about 1.5 kg of dishwasher salt.
3. Fill the salt container to its maximum limit with water, it is normal for a small amount of water to
come out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop being after the salt container has been filled with salt.
6. Immediately after filling the salt into the salt container, a washing program should be started (We
suggest to use a short program). Otherwise the filter system, pump or other important parts of
the machine may be damaged by salty water. This is out of warranty.
WARNING!
• Only use salt specifically designed for dishwashers use! Every other type of salt not specifically
designed for dishwasher use, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor
is liable for any damages caused.
• Only fill with salt before running a cycle. This will prevent any grains of salt or salty water, which
may have been spilled, remaining on the bottom of the machine for any period of time, which
may cause corrosion.
• The salt container must only be refilled when the salt warning light () in the control panel
comes on. Depending on how well the salt dissolves, the salt warning light may still be on
even though the salt container is filled.
• If salt has spilled, run a soak or quick program to remove it.
2. Rinse aid
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes,
which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes.
Your dishwasher is designed to use liquid rinse aids.
WARNING! Only use branded rinse aid for dishwasher. Never fill the rinse aid dispenser
with any other substances (e.g. Dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
When to refill the rinse aid dispenser
This dishwasher is designed to use liquid rinses. The rinse aid tank is located on the door next to
the detergent tank. The tank holds approximately 110 ml of rinse aid.
Unless the rinse-aid warning light on the control panel is on, you can always estimate the amount
from the color of the optical level indicator located next to the cap. When the rinse-aid container is
full, the indicator will be fully
dark. The size of the dark dot decreases as the rinse-aid diminishes.

Содержание

Похожие устройства

Скачать