Home
Главная
First
Утюги
FA-5633-2-GN
Руководство по эксплуатации Страница: 3

First FA-5633-2-GN [3/28] English

BEFORE FIRST USE

• It is normal for small amount of smoke to

be produced the rst time, this will quickly

disappear.

• When using the steam function for the rst

time, do not direct the steam towards the

laundry, as there could be debris from the

steam vents.

FIX THE LOCKING STAND ON THE

IRONING BOARD

• Pull out the bracket from the locking stand

and x it on the ironing board.

SUPPLY OF ELECTRICITY

• Set the iron on the stand and plug in.

FILLING WITH WATER

• Make sure that both the Steam Control

turning Knob and Temperature Control

Dial are in “OFF” position.

• Set the 3-Position switch to 1 position and

remove the cordless iron from the stand.

• Hold the iron upright so that the water-

lling inlet is in a horizontal position.

• Fill with water through Water Filling Inlet

until the water reach the “MAX” mark

indicated on the side of the iron, and

never ll above this mark.

TEMPERATURE CONTROL SETTING

GARMENT

LABEL

FABRIC

TYPE

THERMOSTAT

REGULATION

silk low temperature

wool medium

temperature

lll

Cotton - linen high temperature

• Always check rst to see whether a label

with ironing instructions is attached to

the article to be ironed. Follow these

instruction in all cases.

• First you should sort the laundry: Wool

with wool, Cotton with cotton etc. Start

ironing the fabrics requiring the lowest

temperature and progress to the higher

ones because the iron heats up quicker

than it cools down.

• If the fabric consist of various kinds of

bres (e.g. cotton with polyester) you

must always select the lowest ironing

temperature of the composition of those

bres.

STEAM IRONING

• Place the iron in a vertical position and

set the temperature control dial at the

minimum/low heat setting.

• Insert the plug into the socket, and then

turn the temperature control dial to the

“high heat” marking. The pilot light will

come on, indicating that the iron is heating

up.

• The correct temperature will be reached

when the pilot light has turned off. The

pilot light will be on and off from time

to time indicating that the selected

temperature is being maintained.

• Turn the steam knob to the required

position

• Steam is produced as soon as the iron in

held horizontally.

SPRAYING

• Press the spray button to spray water on

clothes, as often as required.

Note: When using the water spray function,

ensure that there is enough water in the

water tank, and you may have to pump the

spray button serval times at first time you

use the iron in order to start the spraying

function.

SELECTING SHOT-STEAM AND

STEAM WHEN IRONING VERTICALLY

Press the shot-steam button to generate a

powerful burst of steam that can penetrate

the fabrics and smooth the most difficult and

tough creases. Wait for a few seconds before

pressing again.

By pressing the shot-steam button at

intervals you can also iron vertically (curtains,

hung garments, etc.)

Warning: the shot-steam function can only

be used at high temperatures. Stop the

emission when the plate temperature control

light comes on, than start ironing again only

after the light has gone off.

DRY IRONING

To iron without steam, follow the instructions

in section “steam ironing”, leaving the steam

selector on position “OFF”.

ENGLISH

CORDED IRONING

1. Set the 3-position switch to 3 position

2. Take the iron (with power unit)from the

stand for IRONING.

3. Replace the iron (with power unit )on the

stand after used and set the 3-position

switch to 2 position.

CORDLESS IRONING

1. Set the 3-position switch to 1 position.

2. Take the iron(without power unit)from the

stand.

3. Always replace the iron on the stand

during ironing intervals.

4. When the iron is correctly placed on the

stand, the pilot light (K) will illuminate.

5. If the soleplate needs heating up to the

set temperature,the indicator lamp (K) will

also be activated.As soon as the soleplate

has regained the set temperature,this light

will cut out.

6. We advise you to use the iron in the

corded position if you intend to steam

iron for a length of time and when you

apply numerous shots of steam,as this

can cause the soleplate to cool down

considerably.

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir

softens the water and prevents scale build-up

in the plate. The resin filter is permanent and

does not need replacing.

Please note:

Use tap water only. Distilled and/

demineralised water makes the “Zero-Calc”

anti-calc system ineffective by altering its

physicochemical characteristics.

Do not use chemical additives, scented

substances or decalcifiers.

ANTI-DRIP:

This iron is equipped with a drip stop

function: the iron automatically stops

steaming when the temperature is too low

to prevent water from dripping out of the

soleplate.

With the anti-dripping system, you can

perfectly iron even the most delicate fabrics.

HOW TO CLEAN AND STORE

• After using, lift the iron with the lling hole

downwards to empty the remaining water

from the Water tank.

• Insert the plug into the socket, and set the

Temperature Control Dial to “MAX” for 1-2

minutes to evaporate the remaining water,

and then unplug the iron and let it cool

down .

• The iron should be xed in position 2

(storage position) after using.

SPECIFICATIONS

Power: 220-240V • 50/60Hz • 2200W

Environment friendly disposal

You can help protect the environment!

Please remember to respect the local

regulations: hand in the non-working

electrical equipments to an appropriate waste

disposal center.

First FA-5633-2-GN [3/28] English

Содержание

Похожие устройства