ДКС INFOLCD2000SI [40/52] Connection of the ups to the mains and the load

Figure 1. Placing of the UPS

RJ11 connector is used to protect a phone, modem or fax from power surges. One end of

the cable must be connected to the “IN” input; the other, coming from the load, must be

connected to the “OUT” output.

The RS232 / USB connector is used to automatically remote turn off / on and monitor the

status of the UPS. It’s necessary to connect one end of the cable with a USB / RS232

connector to the UPS, and connect the other end of the cable to the computer.

During mains operation, the UPS monitors the input frequency and sets the value to 50

or 60 Hz when operating from the inverter.

4.2 Connection of the UPS to the mains and the load

4. Plug the UPS power cable into a mains socket. Before use, it is recommended to

charge the battery for 10 hours. The battery automatically recharges while the UPS is

connected to the mains.

5. Connect consumers to the UPS output.

6. Phone / Modem / Fax Connection (RJ-11 / RJ-45 devices only)

The telephone pair should be connected to the “in” connector on the rear panel of the

device. A cable form the phone / modem / fax should be connected to the “out”

connector.

4. Connecting the communication cable (only for models with USB / RS232)

It allows remote monitoring of the UPS. Connect the device to the computer with the

cable. Using the software, it’s possible to turn on / off the UPS, as well as monitor its

status from a computer.