Тион 4S Family [12/36] Failure to meet these requirements may cause the device to malfunction

Failure to meet these requirements may cause the

device to malfunction

Before mounting, leave the device in a warm room for 2 hours to avoid device failure, the

formation of condensation, or damage to plastic parts after transportation or storage at low

temperatures.

Do not use in premises with temperatures below 10°С or above 35°С.

Do not use in premises with relative humidity above 80% at 35°С.

Do not use in premises with sources of steam or other significant humidity where there is a

chance of water getting directly onto the device. Such premises include swimming pools,

steam baths, saunas, restrooms and bathrooms.

Avoid prolonged exposure to direct sunlight.

Do not mount or operate without following the instructions provided in this Manual and on

the mounting template.

Do not operate without a prefilter and HEPA filter. Doing so can allow large dust particles to

enter the heater and fan, which may cause them to fail.

Before unplugging the device, turn it off using the control button and wait for a double beep.

Check again for error codes 10 minutes after the beep, then unplug the device from the

socket. Otherwise, the shutter will remain open and outside air will be able to flow through

the device into the premises.

Continued use of used filters with the device can lead to decreased performance, increased

fan noise, and device failure. Only reset the filter counter after replacing the filters.

During lightning storms, the device must be turned off and unplugged from the mains.