Kuppersberg FS 903 B бронзовый [30/68] Wiring

Kuppersberg FG 62 GR [30/68] Wiring
30
TECHNICAL PASSPORT ENGLISH
Built-in gas hob
2.3 Wiring
You should denitely use an earthed
line for the product!
The manufacturing rm shall not be
responsible for any damages that may occur if
the product is used without the earth.
ОElectric shock, short-circuit or re risk
arising from the installation performed by any
unprofessional persons! The product should be
connected to the mains only by an authorized
and qualied person and the warranty of the
product starts only after correct installation.
Power shock, short-circuit or re risk
arising from damaged power cable! The power
cable should be crushed, crinkled or pinched
or should not contact with the hot parts of the
product. If the power cable gets damaged, it
should be replaced by a qualied electrician.
The mains supply data should be
same on the data indicated on the nameplate
of the unit. You may nd the nameplate at the
back of or under the product.
The connection cable of the
product should comply with the technical
specications and power consumption.
Risk of electric shock! Before performing
any work on the electric installation, please
disconnect the power supply of the product.
2.4 Gas connection
 Any work on the gas equipment
and systems should be performed by the
qualied and authorized persons.
 Prior to installation, make sure the
conditions of local distribution (gas type
and gas pressure) comply with the settings
of the product.
2.4.1 LPG connection
 Make sure the gas hose and gas
pressure-reducing valve you use on the
range are safe. Connect the gas delivery
hose with the hose behind the range and
tighten it by using a clamp and screwdriver
(gure 10). Make sure it is rmly tightened.
 Gas delivery hose of the equipment
should not be longer than 1500mm.
 The pressure of the pressure-
reducing valve to be used for LPG should be
300mmSS and certicated.
Gas delivery hose should not pass
through the hot part behind the equipment.
Temperature of the gas hose should not
exceed 90°C (degree).
Prior to use, make sure the system does
not leak any gas.
1. G1/2 Nipple)
2. Silicon seal
3. G1/2 Hose inlet ( gas inlet)
4. Metal clamp
5. Gas hose (inner diameter 8mm)

Содержание

Похожие устройства

Скачать