Home
Главная
Centek
Стиральная Машина
CT-1965
Инструкция по эксплуатации Страница: 44

Centek CT-1965 Инструкция по эксплуатации онлайн [44/56] 810075

4. When connecting the hose to the drain pipe, make sure it is not inserted too

deep so as not to obstruct the sewage flow. If the hose is too long – cut it

down to size.

5. In any case please avoid the siphon effect when connecting the machine to the

drain; otherwise the water will not stop running. For this purpose a part of the

hose should always be raised at least 60 cm above the floor.

Besides, the free end of the drain hose should not be submerged in water

(therefore please avoid connecting the hose to the sewage pipes with a

constant water flow).

draining

NOTE: If the free end of the hose is routed into a sink, use a special holding clamp

(bracket) as in the case with a bathtub; secure the clamp with a chain or rope.

CONNECTING TO POWER SUPPLY

1. The washing machine should be connected to a properly installed grounded

electric socket protected by an automatic circuit breaker of 16A rating.

For added safety it is recommended to connect the washing machine to a

dedicated lead (socket) assigned in the switchboard and used exclusively to

connect the washing machine, protected by a dedicated differential current

circuit breaker or a combined automatic circuit breaker and ground fault

circuit breaker (GFCI).

The manufacturer will not accept liability for any damage if the machine is

connected to a power supply circuit without a functioning earthing connection

installed in accordance with local regulations.

2. The electric circuit to which the machine is connected should be located in

a easily visible and accessible place, within 1 m to the left or right of the

appliance. Please prevent situations when the power cable can be jammed,

tugged at or trampled upon.

3. Never use extension cables or cluster type power sockets to connect the

appliance. This is critical to avoid loose contacts or contacts with insufficient

area and thus to prevent fires. Never connect the appliance via an external

timer.

4. If the power cable is damaged it shall only be repaired by a properly qualified

technician at a service center.

5. OPERATING THE WASHING MACHINE

ATTENTION

Before doing your laundry ensure that the washing machine is installed properly

in accordance with our instructions.

The appliance has undergone quality acceptance tests at the factory, therefore it

may contain water and show minor traces of test operation.

ATTENTION

In order to eliminate any foreign smells and clean the washing machine before

first use, we recommend running the “Hypoallergenic Wash” at 85 °С without

clothes and detergents.

Do not worry if the smell has not gone completely. There may be the smell

emitted by plastic and rubber components that have become very hot during

operation.

In this case either run another washing cycle without clothes at a high

temperature, or wait for the smell to disappear after the first two or three

washing cycles.

BEFORE WASHING

1. Connect the machine to power supply.

2. Open the valve to which the water supply tube is connected.

3. Load the clothes into the machine.

4. Firmly close the door.

5. Add the detergent.

WASHING

1. Select the desired washing program with the selector dial.

2. You can change the washing temperature and drying speed if desired. Please

pay attention to the care instructions tags on the clothes before loading them

into the machine.

3. Select the auxiliary modes and/or functions.

4. Press the «Start/Pause» to start the washing program.

AFTER WASHING

At the end of the washing cycle the word «End» will appear on the display. Wait

for the door to unlock (the lock indicator will go out), open the door and remove

the clothes.

Turn the machine off. Close the water supply valve.

NOTE: We recommend leaving the washing machine door open to allow the

moisture inside to evaporate.

Centek CT-1965 Инструкция по эксплуатации онлайн [44/56] 810075

Содержание

Похожие устройства