Ака Signum 7272M MFT version 1.00 [16/34] Dynamic and static modes

disappear. This is the primary mode your detector is in every time you turn it on.

Static mode is used as an additional and serves mainly to clarify the location of

the found object (Pinpoint). Unlike dynamic mode there is no constant adjusting and

therefore, it is not intended for

a lengthy search. To switch the appliance

from the basic search mode to static mode (Pinpoint)

Click. In the right-hand side of the

value of the gain for the static mode along with the ability

to change this parameter by using the buttons

The gain of the static mode is selected experimentally depending on the specific

conditions. The choice of this parameter will depend on the relief of the ground, littered

area, temperature changes, etc. We recommend starting values of 6-7.

As already mentioned, the active

After locating an object, in the static mode,

and deciding it is worth digging it is time to

define its exact location. To do this,

move the search coil off of the approximate

center of the target either left or right (line A

see Figure 12). Then turn on the

static mode (Pinpoint)

As accurately as possible, while

maintaining the distance between the

Fig.12