Home
Главная
Vitek
Термопот
VT-7115
Инструкция по эксплуатации Страница: 11

Vitek VT-7115 Инструкция по эксплуатации онлайн [11/36] 811732

ENGLISH

Attention! Be careful when pouring out water to

avoid burns by hot water.

There are three options for draining the water from

the thermopot.

Version 1:

– place a suitable bowl under the spout for pour-

ing water (4), for instance, a cup, press the

button (24) «Unlock», then press the water dis-

pense button (3) «Dispense» and hold it until

the bowl is filled to desired level.

Version 2:

– place a suitable bowl under the spout for pour-

ing water (4), press the button (24) «Unlock»

and press the water dispense button (9) with a

rim of the bowl.

Version 3:

– set the manual water dispense locking button

(13) to the position «unlocked» « ».

– place a suitable bowl under the spout for pour-

ing water (4).

– consequently press the manual water dispense

button (13).

– hot water will dispense from the spout (4).

– keep pressing the manual water dispense

button (13) until the bowl is filled to the

desired level.

• To switch the thermopot off disconnect the

power plug (16) from the mains socket.

• Open the thermopot lid (8) and wait until it cools

down completely.

• Carefully tilt the thermopot to drain the remain-

ing water.

• Install the lid (8) back to its place. Before using

the thermopot make sure that the lid (8) is fixed

properly.

• The thermopot is ready to use.

USING THE THERMOPOT

• Open the lid (8) by pressing the button (6), take

the lid (8) and pull upwards.

• Fill the thermopot with water using a suitable

bowl, do not exceed the maximal water level

mark «FULL» (15) on the inner side of the water

tank. Do not pour water above the mark «FULL»

(15), as hot water may splash out when boiled.

• Insert the power cord (16) connector into the

socket (12) on the thermopot body, and the

power cord (16) plug into the mains socket. The

slow boil process will start, the heating indicator

(17) and the lock indicator (20) will glow on the

control panel (5).

• When the temperature 100 °С is reached, the

thermopot will automatically switch to the keep

warm mode at 85 °C. The set temperature keep

warm mode indicator (18) will glow on the

panel (5).

Note:

– Do not open the upper lid during water boiling.

– Do not add water when it’s boiling.

– Do not block the steam release opening (7) of

the upper lid (8).

– The thermopot will maintain the temperature at

85 °С by default.

Heating temperature

To change the required keep warm temperature

consequently press the water temperature setting

button (23) «Temperature selection». The tem-

perature selection indicator will change within the

range «65/85/98 °C».

Note: If the selected temperature is lower than

the temperature in the thermopot, then the wa-

ter in the thermopot will first cool down to the set

temperature, after that the selected temperature

will be maintained. When the water temperature in

the thermopot drops below the set temperature by

more than 5 degrees, the thermopot will switch to

heating mode.

Re-boiling function

You can re-boil cooled water. Press the button «Re-

boil» (22). The boiling indicator (17) will light up.

After the boiling process is finished, the indicator

(17) will go out and the keep warm indicator (18)

will light up. Re-boiling will not start if the water level

in the thermopot is low.

Water dispensing

• Put a suitable bowl under the spout (4).

• Press the button (24) to unlock the water sup-

ply, while the lock indicator (20) on the panel

(5) will go out.

• Press and hold the water dispense button (3)

«Dispense» to fill the bowl or press the bowl rim

to the water dispense button (9). Hot water will

pour from the spout (4) into the bowl as long as

the bowl rim is pressed against the water dis-

pense button (9).

• In case of a power outage, you can easily pour

water by repeatedly pressing the manual water

dispense button, after turning its lock in the

direction of unlocking « ».

Note: if, after unlocking, no action is taken for

about 8 seconds, the water dispense lock will be

Vitek VT-7115 Инструкция по эксплуатации онлайн [11/36] 811732

Похожие устройства