Oleo-Mac 2,8 л.с. bch 50t, леска + диск, 8,3 кг 6151-9050E1 Инструкция к бензиновой косе Oleo-Mac BCH 50T онлайн [30/204] 833354

Check the condition of the fuel filter periodically. To clean the filter, pull it out of the fuel filler

hole; if it is excessively dirty, replace it (Fig. 21).

10.5 ENGINE

Clean the cylinder fins periodically with a brush or compressed air.

CAUTION

If dirt is allowed to build up on the cylinder it could cause overheating and impair

engine performance.

10.6 SPARK PLUG

Regularly clean the spark plug and check the electrode gap (Fig. 22).

Use a TORCH L8RTF spark plug or other brand of equivalent thermal grade.

10.7 BEVEL GEAR

Every 30 working hours, remove the screw (D, Fig. 9) on the bevel gear and check the grease

level.

Use no more than 10 g of quality molybdenum disulfide grease.

10.8 TRANSMISSION

Every 30 working hours, grease the hard tube joint holder (D, Fig. 24) with molybdenum

disulfide grease.

10.9 CARBURETOR

Before adjusting the carburetor, clean the air filter (B, Fig. 23) and run the engine until warm.

The idle speed screw (T, Fig. 20) is adjusted so that there is a good safety margin between the

idle speed and the clutch engagement speed.

WARNING

• With the engine idling (3000 rpm), the blade must not turn. We recommend that

you have your Dealer or Authorized Workshop make all carburetion

adjustments.

• When using the machine above 1000 m of altitude, it is necessary to have the

carburetion checked by an Authorized Service Center.

10.10 MAJOR SERVICING

It is necessary to have the machine inspected by a specialist technician at an Authorized Service

Center at the end of each season, if used intensively, or every two years in the case of normal

use.