ThermoUp Dry Side mirror TUDSm [25/72] Installation recommendations

INSTALLATION RECOMMENDATIONS

INSTALLATION

RECOMMENDATIONS

1. The device should only be attached to the wall in the

position planned upon manufacturing. Do not install

the towel warmer horizontally or upside down. In order

to avoid uneven distribution of weight on the remote

fasteners, the appliance should only be placed on a

at surface and strictly parallel to the oor (use an even

surface and stencil to mark the places where the fasteners

are attached to the wall).

2. The towel warmer must be installed in such a way that the

device and its components — switch, power cord, and wet

towels — are inaccessible to persons who are in the bath

or under the shower. The distance from the water source to

the appliance must be more than 600 mm.

3. Make sure that the appliance is mounted on a wall close

to the power supply so that it can be connected directly

without the need for extension cords. Do not place the

towel warmer directly under the socket. The wires must not

come in contact with the heating surface of the warmer.

4. The distance from the towel warmer to other pieces of

furniture and curtains should be more than 20 cm.

5. If you plan to use a towel warmer as a heater, consider

that the corner of the most effective radiation for heating is

120 degrees, and the objects you wish to heat rst should

be not more than 3 m from the front panel of a towel

warmer.

ThermoUp Dry towel dryers can be used not only for drying textiles, but also for heating bathrooms and other rooms, including

those with high levels of humidity.

For the most efcient and safe use of the device, the following recommendations must be observed:

ATTENTION!

The towel warmer belongs to the II class of electrical safety devices; therefore, in order to connect

it in bathrooms, it is necessary to use moisture- proof electrical sockets connected to an individual

separating transformer or one protected by a protective switchgear, the rated current of which

does not exceed 30 mA.