Home
Главная
GEOS
Электрические
MH 2810 EASY CRUSH 213872
Manual_AL-KO - GEOS 213872 Страница: 26

GEOS MH 2810 EASY CRUSH 213872 Manual_AL-KO - GEOS 213872 онлайн [26/216] 871936

Help in case of malfunctions

Malfunction Possible cause Solution

Machine does not pull in

material to be shredded.

Collector box overflowing due to

material backing up in the cutting

unit.

Empty collector box.

Remove material to be shredded from

the cutting unit, if necessary, see see

chapter 7.4 "Clearing a cutting disk/

cutting drum blockage", page23.

Cutting unit clogged with wet mate-

rial to be shredded.

Clear the clogging by feeding branch

material.

Material to be shredded

is not properly cut.

Blades blunt or damaged Turn or replace the blades, see see

chapter 8.2 "Replacing/turning the

shredder blades (MH 2810) (11/12)",

page24

Motor switches off. Motor protection switch switched

off due to cutting disk overload or

blockage.

The motor can be switched on again

after a cool-down phase of approx.

fiveminutes.

Unusual noises, rattling

in the machine.

Bolts on the motor, its mounting,

the carriage or the cutting unit are

loose.

Re-tighten bolts.

LH 2810

Malfunction Possible cause Solution

Motor does not start. Direction of rotation switch in zero

position.

Turn the direction of rotation switch

to the left or right.

Collector box missing or not

locked.

Push collector box in completely and

lock it.

Mains socket (house installation)

defective.

Use a different mains socket in the

house.

Extension lead defective. Inspect the lead and replace it, if

necessary.

Machine does not pull in

material to be shredded.

Direction of rotation of the cutting

drum incorrect.

Turn direction of rotation switch to

the left (normal operation).

Collector box overflowing due to

material backing up in the cutting

drum.

Empty collector box.

Remove material to be shredded

from the cutting unit, if necessary,

see see chapter 7.4 "Clearing a cut-

ting disk/cutting drum blockage",

page23.

Cutting drum clogged with wet ma-

terials to be shredded.

Clear the clogging by feeding branch

material.

Material to be shredded

is not properly cut.

Counterplate in the cutting unit not

correctly adjusted.

Readjust the counterplate, see see

chapter 8.3 "Re-adjusting the coun-

terplate (LH 2810) (07)", page25.