Buffalo TS3400D0804 [153/181] Applying settings

152

4 From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the TeraStation.

5 Select "Save current configuration to a USB drive", then click Execute.

Troubleshooting:

If the settings are not saved to the USB memory device successfully, you may receive the error message "The specified

operation cannot be executed.". Verify:

• The device is connected to a USB 2.0 port, not a USB 3.0 port.

• The device has a capacity of 1 GB or larger.

• The device is not write-protected.

5 Select "Transfer settings from a USB drive", then click Execute.

Restoring Factory Defaults

There are several ways to initialize the TeraStation and restore its factory default settings. One simple way to do this is to

hold down the init button (refer to the TeraStation diagram in chapter 1) on the front panel for three seconds. Normally

this will reset the admin username and password, network configuration, SSL, and security port settings to their factory

default values. However, this button can be disabled in Settings. If the init button is disabled, refer to the methods below