Home
Главная
Denzel
Машины углошлифовальные (УШМ)
AG230-2400
Руководство по эксплуатации Страница: 12

Denzel AG230-2400 Руководство по эксплуатации онлайн [12/32] 664237

ANGLE GRINDER

To prevent dust and grease leakage this machine has a hermetic design. Therefore, the tool can be used for a long

time and you have no need to replace or add grease. After initial commissioning change lubrication every 6

months of operation. To replace the lubricant, contact the service center.

In case of any damage to the power cord turn o the Angle Grinder immediately, carefully, without touching

the places of damage, disconnect it from the mains.

ATTENTION!

The tool uses power cord with mounting type Y: for security it must be replaced by authorized

repair shop personnel.

Possible faults

Fault Probable cause Problem solution

The tool does not turn on.

Broken power cord or mounting

wire, malfunction of power cord

plug.

Call the service center.

Defective switch. Call the service center.

Brush wear. Call the service center.

Circular re on the collector.

Fault in the armature winding. Call the service center.

Wearout /«hang» of brushes. Call the service center.

Increased noise in the gear.

Wearout / breakage

of the mechanism parts.

Call the service center.

When working smoke or smell

of burning insulation

is generated from the vent.

Interturn closure of armature

or stator windings.

Call the service center.

Malfunction of the electrical part

of the instrument.

Call the service center.

Increased machine vibration.

Wearout / breakage of gears

or bearings.

Call the service center.

Faulty or improperly installed

tooling.

Replace or reinstall a tooling.

RECYCLING

A tool, developed a designated service life, must be recycled according the rules established by environmental

and other laws of the country, where the tool is operated.

TRANSPORTATION

During the transportation direct exposure of precipitation, direct sunlight, heat and shock is not allowed.

Transportation should be carried out only in the original packaging at temperature from - 20 °С to + 40 °С.

STORAGE

During the assigned service life, store the machine in a dry heated room. Recommended storage temperature

is from 0 °C to +40 °C. Store the tool in the original packaging.

Before placing the drill in storage remove the working tool.

Denzel AG230-2400 Руководство по эксплуатации онлайн [12/32] 664237

Похожие устройства