Home
Главная
Honda
Мотоцикл
HORNET CB600FW (1996)
Инструкция по эксплуатации Страница: 275

Honda HORNET CB600FW (1996) [275/372] Inspection

Содержание

Похожие устройства

REAR WHEEL SUSPENSION Remove the shock absorber upper mounting bolt nut and shock absorber INSPECTION Visually inspect the damper unit for damage Check for the Damper rod for bend or damage Damper unit for deformation or oil leaks Bump rubber for wear or damage Spring for damage Inspect all the other parts for wear or damage If necessary replace the shock absorber as an assembly SHOCK ABSORBER DISPOSAL PROCEDURE Center punch the damper to mark the drilling point Wrap the damper unit inside a plastic bag Support the damper in a vise as shown Through the open end of the bag insert a drill motor with a sharp 2 3 mm 5 64 1 8 in drill bit WARNING Do not use a dull drill bit which could cause a build up of excessive heat and pressure inside the damper leading to explosion and severe personal injury The shock absorber contains nitrogen gas and oil under high pressure Do not drill any farther down the damper case than the measurement given above or you may drill into the oil chamber oil escaping under high pressure may cause serious personal injury Always wear eye protection to avoid getting metal shaving in your eyes when the gas pressure is released The plastic bag is only intended to shield you from the escaping gas 14 11 Hold the bag around the drill motor and briefly run the drill motor inside the bag this will inflate the bag with air from the motor and help keep the bag from getting caught in the bit when you start

Скачать

Случайные обсуждения

Ответы 0

В коробку масло заливается или всё смазывается вместе с поршневой 🤔

5 месяцев назад