Suunto Cobra3 [33/60] Oxygen limit fraction olf
Превью страниц
Страница 33 /
60
![Suunto Cobra3 [33/60] Oxygen limit fraction olf](/views2/1013658/page33/bg21.png)
UP BUTTON
TOGGLES
BETWEEN PO
2
,
OLF, DIVE TIME
AND WATER
TEMPERATURE.
DOWN BUTTON
TOGGLES
BETWEEN O
2
,
MAXIMUM DEPTH
TANK PRESSURE
AND CURRENT
TIME.
6.2.3. Oxygen limit fraction (OLF)
If set to NITROX mode, in addition to tracking the diver's exposure to nitrogen, the
instrument tracks the exposure to oxygen. These calculations are treated as entirely
separate functions.
The dive computer calculates separately for Central Nervous System oxygen toxicity (CNS)
and Pulmonary Oxygen toxicity, the latter measured by the addition of Oxygen Toxicity
Units (OTU). Both fractions are scaled so that the maximum tolerated exposure for each
is expressed as 100%.
The Oxygen Limit Fraction (OLF) displays only the value of the higher of the two
calculations. The oxygen toxicity calculations are based on the factors listed in Section 10.3.
Oxygen exposure .
6.2.4. Gas change and multiple breathing gas mixes
The Suunto Cobra3 allows gas changes to enabled gas mixes during the dive. Gas changes
are made by following the procedure below:
CHANGING GAS MIX. SCROLL
THROUGH ENABLED MIXES BY
PRESSING THE UP OR DOWN
BUTTONS. SELECT NEW MIX BY
PRESSING THE SELECT BUTTON.
NOTE
Mix number, O
2
% and PO
2
for the mixes are shown when scrolling.
If the set PO
2
limit is exceeded , it will be shown with the PO
2
value
blinking. The dive computer does not allow you to change to a gas
whose set PO
2
is exceeded. In such a case, the mix is shown but
cannot be selected.
NOTE
If no button is pressed in 15 seconds, the dive computer will go back
to the dive display without changing the gas mix. Upon ascent, the
computer prompts you to change gas when the PO
2
level you have
set for the next mix allows a gas change. The prompt is an audible 3
beeps and the current O
2
mix starts to blink.
6.3. Diving in GAUGE mode (DIVEgauge)
If set to GAUGE mode, the dive computer can be used as a bottom timer.
33
Содержание
116- User s guide
- Cobra3
- Table of contents
- Welcome to the world of suunto diving instruments
- Warnings cautions and notes
- Suunto at a glance
- Navigating in the menus
- Button symbols and functions
- Time mode settings
- Setting the time
- Setting the date
- Setting the alarm
- Getting started with your suunto cobra3
- Setting the units
- Setting the tones
- Setting the backlight
- Ac water contacts
- Locking a bearing
- Learning how to use your compass
- Compass display
- Compass settings
- Calibration
- You can exit the compass mode also by long pressing the select button
- Time out you can set the compass time out to 1 3 or 5 minutes after the set time has passed from the latest button press the dive computer returns to the time or dive mode from the compass mode
- Time out
- If the calibration fails several times in a row it is possible that you are in an area with sources of magnetism such as large metal objects power lines or electric appliances move to another location and try to calibrate the compass again if the calibration continues to fail contact an authorized suunto service center
- Declination you can compensate for the difference between true north and magnetic north by adjusting the compass declination the declination can be found for example from sea charts or topographic maps of the local area
- Declination
- The suunto rgbm deep stop algorithm
- Emergency ascents
- Dive computer limitations
- Before diving
- Nitrox
- Audible and visual alarms
- Error conditions
- Air integration
- Setting the dive time alarm
- Setting the depth alarm
- Dive mode settings
- Connecting suunto cobra3 to a regulator
- Setting the personal altitude adjustments
- Setting the nitrox values
- Setting the units
- Setting the tank pressure alarm
- Setting the sample rate
- Setting the safety stops deep stops
- Setting the rgbm values
- Dive mode activation
- Activation and pre checks
- Accessing dive mode
- Diving at altitude
- Battery power indication
- Personal adjustments
- Safety stops
- Recommended safety stops
- Mandatory safety stops
- Deep stops
- Diving in air mode diveair
- Diving
- Basic dive data
- Tank pressure data
- Bookmark
- Safety stops
- Decompression dives
- Ascent rate indicator
- Display below the floor
- Ceiling ceiling zone floor and decompression range
- Display above the ceiling
- Display at the ceiling zone
- Display above the floor
- Oxygen displays
- Diving in nitrox mode divenitrox
- Default nitrox settings
- Before diving in nitrox mode
- Oxygen limit fraction olf
- Gas change and multiple breathing gas mixes
- Diving in gauge mode divegauge
- Surface interval
- Repetitive dive planning
- Dive numbering
- After diving
- Plan mode
- Flying after diving
- Dive planning mode plannodec
- Simulation mode plansimulator
- Dive simulator
- Dive numbering shown during dive planning
- Memory mode
- Dive logbook memlogbook
- Dive history memhistory
- Www suuntosports com and suunto diving world at www suunto com diving
- Suunto dive manager sdm
- Care and maintenance of my suunto diving computer
- Required tools
- Replacing the battery
- Battery replacement
- Battery kit
- Technical specifications
- Technical data
- Suunto rgbm adaptive decompression
- No decompression limits
- Oxygen exposure
- Altitude diving
- Trademark
- Patent notice
- Intellectual property
- Copyright
- User s responsibility
- Disclaimers
- Suunto limited warranty for suunto diving computers and suunto diving computer accessories
- Disposal of the device
- Glossary
- Customer service contacts
- Copyright
- Two year warranty
- Www suunto com
Похожие устройства
-
Suunto CobraИнструкция по эксплуатации -
Suunto Cobra2Инструкция по эксплуатации -
Suunto ComboИнструкция по эксплуатации -
Suunto D4iИнструкция по эксплуатации -
Suunto D6Инструкция по эксплуатации -
Suunto D6iИнструкция по эксплуатации -
Suunto D9Инструкция по эксплуатации -
Suunto D9txИнструкция по эксплуатации -
Suunto GekkoИнструкция по эксплуатации -
Suunto HelO2Инструкция по эксплуатации -
Suunto StingerИнструкция по эксплуатации -
Suunto VyperИнструкция по эксплуатации