Kramer VS-41HD [10/23] Connecting your vs41hd 4x1 hd sdsdi switcher da

Connecting Your VS-41HD 4x1 HD/SD-SDI Switcher / DA

6 Connecting Your VS-41HD 4x1 HD/SD-SDI Switcher / DA

You can use your VS-41HD to switch one of the four standard definition / high

definition SDI inputs to the two identical high definition / standard definition

SDI outputs, as the illustration in

Figure 2 shows.

To connect the VS-41HD 4x1 HD/SD-SDI Switcher / DA, as shown in the

example in

Figure 2, do the following

1. Connect up to four SDI sources to the INPUTS BNC connectors:

 An HD/SD SDI camera to INPUT 1

 An HD SDI camera to INPUT 2

 An HD SDI camera to INPUT 3

 An SDI VTR to INPUT 4

2. Connect the SDI OUTPUT BNC connectors to up to

3. Set the dipswitches (see section

two SDI acceptors (for

example, two HD/SD SDI displays).

6.1).

4. As an option

 A Genlock source to the GENLOCK BNC connector

, connect:

 The LOOP BNC connector to the GENLOCK

connector of the next unit in the line, and release the

TERM button for looping

5. Connect a PC and/or controller (if required), to the:

 RS-232 port (see section

6.2), and/or

 RS-485 port (see section

6.3), and/or

 ETHERNET connector (see section

6.4)

6. If required

, connect a remote contact closure switch (see section 6.6)

7. Connect the power cord

1 Switch OFF the power on each device before connecting it to your VS-41HD. After connecting your VS-41HD, switch on

its power and then switch on the power on each device

2 When only one output is required, connect that output, and leave the other output unconnected

3 Not illustrated in

Figure 2

4 Pushed in terminates the input. Release when the input extends to another unit

5 We recommend that you use only the power cord that is supplied with this machine