Kramer VP-793 Руководства по эксплуатации онлайн [20/31] 140338

3.7.1. Horizontal and Vertical Position

Available Settings: in steps of 1 pixel and line

Change the positional values to match the display boarders.

3.7.2. Edge Control

Submenu for changing the position of the image edges, effectively scaling the image in horizontal and

vertical direction. If Pan Tilt Zoom is activated Edge Control is disabled. It does effectively the same, but

has greater range.

3.7.3. Picture Format

Available Settings: Standard, Full Screen, Crop, Anamorphic

Picture Format allows a user to select the displayed aspect ratio where the signal input is at variance

with the display panel’s natural aspect ratio.

Note that some aspect ratios may not be applicable to all signal types, in which case selecting a non-

applicable aspect ratio conversion will have no effect on the displayed image. When a 16:9 image is

displayed on a 16:9 panel all settings give an identical full screen image.

Standard preserves the aspect ratio of the incoming image and scales the image to fit into the size of

the panel. Dependant on the aspect ratio of the panel the image is either bordered by the right and left

side or bottom and top of the panel. Non-used areas of the panel are displayed black (letterboxed).

Full Screen scales the image to the size of the panel without preservation of the aspect ratio.

Crop preserves the aspect ratio and scales the image to fit the screen. Dependant on the aspect ratio of

the panel either the top and bottom or right and left areas of the image are cropped.

Anamorphic scales the input image such that it is displayed with a 16:9 aspect ratio when displayed on

the screen. The image is further scaled to fit into the size of the panel. Dependant on the aspect ratio of

the panel the image is then either bordered by the right and left side or bottom and top of the panel.

Non-used areas of the panel are displayed black (letterboxed).

3.7.4. Overscan

Available Settings: 0 to 10 in steps of 1

Overscan is used to slightly zoom into the image. This can be used to cut off unwanted features.