Kramer T1AF Руководства по эксплуатации онлайн

The Kramer T1AF-14L Inner Frame

Congratulations on purchasing your Kramer T1AF-14L inner frame for the TBUS-1Axl Table

Connection bus.

The T1AF-14L inner frame includes:

• An opening for 1 power socket • 2 cable pass-through inserts

• 2 blank inserts • An opening for the Kramer SI-1VGA / RC-3TB

Figure 1: T1AF-14L Inner Frame (P/N: 80-000699)

Power Socket and Power Cord Options

Various power sockets and power cords are available to use with the T1AF-14L, as described

in the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,

supplied with the power socket.

Each power socket comes with detailed assembly instructions.

The T-2INSERT Kit Option (80-00006699)

You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)

instead of a power socket.

Mounting the Inserts

Go to http://www.kramerelectronics.com to check for up-to-date

user manuals and the complete list of Kramer wall plates and

module connectors.

You can rearrange or remove any of the plates mounted on the inner frame and replace them

with Kramer passive wall plates or connector modules for interfacing A/V type signals.

To mount a Kramer insert or connector module:

1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the

blank plate.

2. Place the required Kramer insert over the opening, insert the two screws to fix the

Kramer insert in place, and tighten them.

Installing the SI-1VGA / RC-3TB

To install the SI-1VGA / RC-3TB module, place it under the designated opening and then

screw and tighten it in place using two screws supplied with the inner frame.

Installing the Assembled Inner Frame

To install the T1AF-14L inner frame:

1. Place the assembled inner frame inside the TBUS-1Axl enclosure.

2. Set the required height using your fingers to bring the inner frame to the desired

position, screw and tighten it in place using the height adjustment screws supplied with

the inner frame.

Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so

on):

1. Insert the cables to their appropriate connectors from underneath.

2. Secure the cables to the tie holes on the TBUS-1Axl.

Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

After the TBUS-1Axl is connected to mains power and the proper cables, it is ready for use.