BBE MAX-X2 [8/12] Max x2 typical setup

Содержание

• Safety related symbols p.2
• Contents p.3
• Specifications p.4
• Gett ng started p.5
• Caution to prevent malfunctioning and or possible equipment damage before plug ging the unit into the power source 1 the voltage selector switch should be set for the correct voltage for your area 115v or 230v and 2 all equipment connected to the crossover outputs should be turned off or all the inputs turned down p.5
• Introduction p.5
• Getting started p.5
• Max x2 front panel p.6
• Front panel p.6
• Caution before pressing the phase switches always lower the outputs of your power amplifiers to avoid possible speaker damage p.6
• Rear panel p.7
• Max x2 rear panel p.7
• 4 3 2 4 3 p.7
• Max x2 typical setup p.8
• Installation p.8
• In this chapter you ll find the wiring diagrams for the connectors to be used with your crossover take care of the connector cable always holding them by the connectors and avoiding knots and twists when coiling them this gives the advantage of increasing their life and reliability which is always to your advantage periodically check that your cables are in good condition that they are correctly wired and that all their contact are perfectly efficient a great number of problems faulty contacts ground hum discharges etc are caused entirely by using unsuitable or faulty cables p.9
• Connection cables p.9
• Balanced xlr m p.9
• Balanced xlr f p.9
• Balanced 1 4 plug p.9
• Xlr male jack unbalanced link p.9
• Xlr female jack unbalanced link xlr female jack unbalanced link p.9
• Installation p.9
• Warranty p.10
• Do not return any product to the above address without instructions and authorization issued by the above location p.10