Canon imagePROGRAF iPF6300 [962/1126] Configuring tcp ipv6 network settings

3. Execute the following command to add entries to the ARP table for managing IP addresses and corresponding MAC

addresses.

arp -s [IP address] [the printer's MAC address you have verified]

Example: arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx

Note

• In Mac OS X when using Terminal, enter the arp command in the format

arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx.

For details, refer to the help file for the command line.

Execute the following command to send the IP address to the printer and configure it.

ping [IP address as specified in the ARP command] -l 479

Example: ping xxx.xxx.xxx.xxx -l 479

Note

• In -l, the l is the letter l.

• In Mac OS X when using Terminal, enter the ping command in the format

ping -s 479 xxx.xxx.xxx.xxx.

For details, refer to the help file for the command line.

Note

• The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and de-

fault gateway to match your network settings.

For details on RemoteUI, see "Using RemoteUI ." →P.938

Configuring TCP/IPv6 Network Settings

When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.

Follow the steps below to configure the TCP/IPv6 network settings.

1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).

Note

• If the Tab Selection screen is not displayed, press the Menu button.

2. Press the OK button.

The Set./Adj. Menu is displayed.

3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.

4. Press ▲ or ▼ to select TCP/IP, and then press the OK button.

Network Setting

Initial Settings

Configuring TCP/IPv6 Network Settings iPF6300S

944