Ea2 BL506 [10/11] Precautions

Ea2 BL506 [10/11] Precautions
ENGLISH 7 ENGLISH 8
7.3 Snooze Alarm Clock Function:
Press “ ALARM” button (B3) once see the alarm time (“AL” shown on the LCD):
Press “Alarm” twice, to turn ON/OFF the alarm function. When alarm on, shown
on the LCD.
When viewing alarm time, hold “ALARM” button (B3) for 3 seconds to enter the Alarm
Time setting. Press “▲” (B6) or “ ▼ ” (B7) button to adjust the alarm time, and press
“ALARM” button (B3) to conrm the setting.
When alarming, press “SNOOZE/LIGHT” (B1) button to activate snooze alarm. “
ash on the LCD. The alarm will snooze for 5 minutes, then it alarms again. This
snooze function can be enabled for maximum 7 times.
Except “SNOOZE/LIGHT” (B1) button, press any button to stop the snooze alarm.
8. Low batteries indication:
The low battery icon “ ” will appear at particular channel indicating that thermo sensor
unit of the channel is in low battery status. The batteries should be replaced.
9. Projection & Backlight
Press “SNOOZE/LIGHT” (B1) button, the projection and backlight shine for around 20
seconds.
When DC adaptor plug in, push “PROJECTION ON/STANDBY” (B9) slide switch
to “ON”, the projection and back light will turn on and not auto off. Push the switch
to “STANDBY”, press “SNOOZE/LIGHT” (B1) button to turn on the back light and
projection for around 20 seconds.
Indoor Data:
Temperature range: -5 to 50°C [23 to 122°F]
Temperature Units Measured: °C or °F [switchable]
Outdoor Data:
Transmission distance: (open area) 30m @ 433MHz
Temperature range: -40 ~ 50°C [-40 ~ 122°F]
Mount: table
Main Unit Dimensions: W158 x h87x d48 mm
Thermo Sensor Dimensions: w65 x h84 x d18 mm
Battery Requirements:
Base Station [indoor]: 3 x AAA batteries
Sensors [outdoor]: 2 x AAA batteries
Adaptor Output: DC 4.5V, 250mA
11. Specications
10. Precautions
Use a pin to press the reset button (B4) if the Unit does not work properly.
All Setting Modes will automatically exit in 15 seconds without any adjustment.
Avoid placing the clock near interference sources/metal frames such as computer or
TV sets.
Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
The outdoor sensor must not be set up and installed under water. Set it up away direct
sunlight and Rain
Never clean the device using abrasive or corrosive materials or products. Abrasive
cleaning agents may scratch plastic parts and corrode electronic circuits
Скачать