Gigabyte ga-x150-plus ws [16/44] Spdif_o s pdif out header

9) F_PANEL (Front Panel Header)

Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header

according to the pin assignments below. Note the positive and negative pins before connecting the cables.

10) SPDIF_O (S/PDIF Out Header)

 ThisheadersupportsdigitalS/PDIFOutandconnectsaS/PDIFdigitalaudiocable(providedby

expansioncards)fordigitalaudiooutputfromyourmotherboardtocertainexpansioncardslikegraphics

cardsandsoundcards.Forexample,somegraphicscardsmayrequireyoutouseaS/PDIFdigital

audio cable for digital audio output from your motherboard to your graphics card if you wish to connect

anHDMIdisplaytothegraphicscardandhavedigitalaudiooutputfromtheHDMIdisplayatthesame

• PW(PowerSwitch,Red):

Connects to the power switch on the chassis front panel. You may

congure thewaytoturnoffyoursystemusingthepowerswitch

(refer to Chapter 2, "BIOS Setup," "Power Management," for more

information).

• SPEAK (Speaker,Orange):

Connects to the speaker on the chassis front panel. The system reports

system startup status by issuing a beep code. One single short beep

will be heard if no problem is detected at system startup.

• PLED/PWR_LED (PowerLED,Yellow/Purple):

off when the system is in S3/S4 sleep state

orpoweredoff(S5).

The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch,

powerLED,harddriveactivityLED,speakerandetc.Whenconnectingyourchassisfrontpanelmoduletothis

header, make sure the wire assignments and the pin assignments are matched correctly.

 ConnectstotheharddriveactivityLEDonthechassisfrontpanel.TheLEDisonwhentheharddriveis

1

2

19

20

CI-

CI+

Reset

NC