Home
Главная
Korting
Вытяжка
khp 6211 gn
Инструкция по эксплуатации Страница: 6

Korting khp 6211 gn [6/36] Use and maintenance

which are suitable for the type of cabinet, making holes in ac-

cordance with the diagram shown in Fig.1. To fit the appliance

correctly, align the front panel of the cooker hood with the

cabinet door and adjust spacer L using screws P (Fig.2), then

ensure the appliance meets the cabinet at the rear.

•Extractionthroughanoutsidewall:

The appliance expels the fumes through an outside wall or

a duct. It is necessary to buy a telescopic pipe in accordance

with the standards in use (inflammable) and connect it to

flange H (Fig.3A).

•Recirculation:

To transform the cooker hood from the extraction version to

the re circulating one ask your supplier for an activated carbon

filter. The filter must be fitted to the extracting group cooker

hood in the centre of the fan grille by twisting it by 90 degrees

until it is gripped securely (Fig.5). For this operation remove the

anti-grease filter(s) G (Fig.4). The clean air is returned into the

room through a connecting tube passing inside the cupboard

and connected to the ring H (Fig.3B).

USE AND MAINTENANCE

•We recommend that the cooker hood is switched on before

any food is cooked. We also recommend that the appliance is

left running for 15 minutes after the food is cooked, in order

to thoroughly eliminate all contaminated air. The effective

performance of the cooker hood depends on constant main-

tenance; the anti-grease filter and the active carbon filter both

require special attention.

•Theanti-greasefilter is responsible retaining the grease

particles suspended in the air, therefore it is subject to clog-

ging with variable frequency according to the use of the

appliance.

- To prevent the danger of possible fires, at least every 2

months one must wash the anti-grease filters by hand using

non-abrasive neutral liquid detergents or in the dishwasher

at low temperatures and on short cycles.

- After a few washes, colour alterations may occur. This does

not give the right to claim their replacement.

•Theactivecarbonfilters are used to purify the air that is

sent back into the room and its function is to mitigate the

unpleasant odours produced by cooking.

- The non-regenerable active carbon filters must be replaced

at least every 4 months. The saturation of the active charcoal

depends on the more or less prolonged use of the appliance,

on the type of kitchen and on the frequency with which anti-

grease filter is cleaned.

•Beforeremountingtheanti-greasefiltersandtheregen-

erable active charcoal filters it is important that they are

completely dry.

•Cleanthehoodfrequently,bothinternallyandexter-

nally, using a cloth dampened with denatured alcohol or

neutral liquid detergents that are non abrasive.

•The lighting .system is designed for use during cooking

and not for the prolonged general lighting of the room. The

prolonged use of the lighting system significantly decreases

the average duration of the bulbs.

•If the appliance is equipped with courtesy lights it is possible

to use them for general room lighting for a prolonged amount

of time.

•Attention: the non compliance with the hood cleaning

warnings and with the replacement and cleaning of the filters

entails risk of fires. One therefore recommends keeping to the

suggested instructions.

•Replacinghalogenlightbulbs(Fig.6):

To replace the halogen light bulbs B, remove the glass pane C

using a lever action on the relevant cracks. Replace the bulbs

with new ones of the same type. Caution: do not touch the

light bulb with bare hands.

•Commands(Fig.7)sliderthe key symbols are explained

below:

A = Light switch

A1 = Off key

A2 = On key

B = Speed control

B1 = Off key

B2 = FIRST SPEED key

B3 = SECOND SPEED key

B4 = THIRD SPEED key

C = Gemma warning light key.

•Replacingthehalogen/incandescentlamps(Fig.8):

Only use lamps of the same type and wattage installed on

the device.

•Commands(Fig.9.1)sliderthe key symbols are explained

below:

This hood is fitted with a microswitch which allows the activa-

tion of the motor speed) through the opening of the telescopic

undercarriage. If the telescopic undercarriage is closed the

motor speeds cannot be activated. This microswitch does

not have an impact on the activation of the lights which must

be switched on through the appropriate switch (see Fig.9A).

A = Light switch

A1 = Off key

A2 = On key

B = Speed control

B1 = FIRST SPEED key

B2 = SECOND SPEED key

B3 = THIRD SPEED key.

Warning! If the telescopic undercarriage is closed with the

speed set at 2, once it is re-opened, the hood will be reacti-

vated with the same speed in use when the hood was closed.

•Slidercontrols(Fig.9.2),thesymbolsareshownbelow:

This hood is equipped with a microswitch.

If the telescopic trolley is closed with the speed set i.e. at 2 and

the light are on, once it is reopened, the hood reactivates at

the same working speed at which it was switched off.

A = FIRST SPEED Off/On Switch

B = SECOND SPEED Switch

C = THIRD SPEED Switch.

D = Light On/Off Switch

•Commands(Fig.10):

Push-button A = On/off lights switch.

Push-button B = On/off cooker hood switch. The appliance

switches on at speed level 1, If the cooker hood is on depress

the push-button for 2 sec. to switch off the cooker hood. If

the cooker hood is at speed level 1 it will not be necessary

to depress the push-button to switch the cooker hood off.

Decreases the motor speed.

Display C = Indicates the motor speed level selected and

activates the timer.

Push-button D = Switches on the cooker hood. Increases the

motor speed. Touching the key at 3rd speed, the intensive

function runs for 10’, then the appliance go back to work at

- 6 -

Korting khp 6211 gn [6/36] Use and maintenance

Содержание

Похожие устройства