Aquael STERILIZER PS UV PS - 11 W [9/52] Sterilizer uv ps

Aquael STERILIZER PS UV PS - 9 W [9/52] Sterilizer uv ps
STERILIZER UV ps
9
power-on lamp (A) – diode signaling operation of the uorescent lamp.
SAFE USAGE CONDITIONS
Prior to installation and every start of the device, read the present
operating and assembly manual carefully.
Upon launching, maintenance and other work in the water tank,
disconnect the device from the power grid by pulling the plug from
the power supply socket.
The device generates radiation harmful to the skin and eyes. Never
turn on the device with the housing removed!
The device may be powered only from a power grid of nominal pa-
rameters (voltage and frequency) specied on the device housing
from a power supply socket located in a dry place. The power sup-
ply grid should have a differential current circuit breaker of leakage
current of 30mA.
In case of damage disconnect the device from power supply im-
mediately. The device with a damaged power cord or quartz glass
cover may not be operated further. It is not allowed to repair or
replace the power supply cord!
In case of frost risk, the sterilizer must be turned off, drained of
water, and stored until springtime in a place protected from frost.
Other special regulations may be in force regarding the use of
the sterilizer in various countries.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the applian-
ce by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
PREPARATION FOR LAUNCHING
I. INSTALL THE FLUORESCENT LAMP
Prior to launching the sterilizer, insert the uorescent lamp, pro-
ceeding as follows:
1. turn the tting grip (10) clockwise, according to the „OUT” arrow
(g. ),
2. remove the tting (10),
3. press the uorescent lamp (8) into the tting (10) until locked,
NOTE Do not touch the uorescent lamp glass; remove possible
marks with a dry cloth.
4. place the tting (10) along with the tted uorescent lamp (8) in the
quartz housing (7).
II. CONNECT THE STERILIZER TO THE WATER CIRCUIT
NOTE Water owing through the sterilizer should be mechanically
ltered (by the preliminary lter).
The sterilizer should be fed by means of a pump. It may be installed both

Содержание

Похожие устройства

Скачать