Tp-Link TD-W8901G Инструкция по эксплуатации онлайн [63/109] 16819

Tp-Link TD-W8901G Инструкция по эксплуатации онлайн [63/109] 16819
TD-W8901G
54Mbps Wireless ADSL2+ Modem Router User Guide
Руководство пользователя: беспроводной
маршрутизатор 54Мбит/с с модемом ADSL2+
Чтобы добавить новый маршрут воспользуйтесь кнопкой ADD ROUTE (Рис. 4-24).
Figure Рис. 4-40
Destination IP Address: This parameter specifies the IP network address of the final
destination. Destination IP Address: Данный параметр задает IP-адрес пункта
назначения.
IP Subnet Mask: Enter the subnet mask for this destination. IP Subnet Mask: Введите
маску подсети для данного пункта назначения.
Gateway IP Address: Enter the IP address of the gateway. The gateway is an immediate
neighbor of your ADSL Router that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your Router; over Internet (WAN), the
gateway must be the IP address of one of the remote nodes. Gateway IP Address: IP-
адрес шлюза. Шлюз - это ближайший к ADSL маршрутизатору узел, который
осуществляет передачу пакета в пункт назначения. Для локальной сети шлюзом
должен быть маршрутизатор, находящийся в том же сегменте, что и ваш
маршрутизатор; для сети Интернет (WAN) шлюзом должен быть IP-адрес одного из
удаленных узлов.
Metric: Metric represents the "cost" of transmission for routing purposes. IP Routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The number need not to be precise,
but it must between 1 and 15. In practice, 2 or 3 is usually a good number. Metric: в данном
поле отображается «стоимость» передачи для целей маршрутизации. При IP-
маршрутизации в качестве средства измерения «стоимости» используется счетчик
пересылок (hop count). Минимальное значение для соединенных напрямую сетей
равно 1. Укажите приблизительную «стоимость» соединения. Это необязательно
должно быть точным числом, но данное значение должно лежать в пределах от 1 до
15. На практике обычно используется значение 2 или 3.
Announced in RIP: This parameter determines if the ADSL router will include the route to
this remote node in its RIP broadcasts. If set to Yes, the route to this remote node will be
propagated to other hosts through RIP broadcasts. If No, this route is kept private and is not
52

Содержание