Windoro wcr-i001 yellow [14/18] Www iwindoro com

Windoro wcr-i001 yellow [14/18] Www iwindoro com
DEIT GB
Usage
Since this product contains strong permanent magnets, if you do not follow the directions below, you can be seriously injured or the product
can be damaged.
14
www.iwindoro.com
STRONG
WEAK
OFF
OFF
Control
Check the inside and outside devices of WINDORO before using the product.
1
Clean the wheels of the inside and outside devices. Dust and foreign substances formed on the wheels cause the product to slip or not to operate properly.
Check the bottoms of the inside and outside devices. Foreign substances such as nails or wires can cause damage to the window.
Pour the WINDORO detergent into the inlet of the outside device to a maximum of 40 millilitres.
Attach the pads on the bottom of the outside cleaning tool.
Attaching the product.
3
WEAK
• Turn the magnetic force controller onto weak.
• Attach the inside and outside device with the handles pointing in the same direction. If they point in different directions, the product cannot be attached
or can be attached incorrectly because of the differences of the magnetic N-S forces.
• Attach the product 10 centimetres from the window frames.
• After attaching the product, check the Control LED of the inside device for the state of the magnetic force. The product works only when the Control LED
is green. Turn the magnetic force controller if necessary.
- Red: the magnetic force is too strong or weak to work. Turn the controller onto weak or strong.
- Green: the magnetic force is ready to work. However, despite being green, the magnetic force can be a little bit weak depending on the situation.
Turn on the inside and outside devices.
2
• Turn on the power switch on the top of the inside device and on the side
of the outside device.
• Turn on the power for the inside and outside devices by pressing the buttons
on the top of the devices.
• Inside device: press the POWER/STOP button for more than 2 seconds, and
the lamp light will be turned on with a beeping sound.
• Outside device: press the POWER button for more than 2 seconds, and
the lamp light will be turned on with a beeping sound.
• Charge the product with the WINDORO adapter.
Turn off the power switch of the inside and outside devices. When the
power is on, charging is impossible.
• The LED is red whilst being charging, and it turns green when the charging
process is completed.
When the Charge LED is red, charging is needed.
Follow the instructions below when recharging.
10cm
10cm
Tip
if the window is very dirty, put a little amount of the detergent onto the pads, or clean the window again after changing the pads for maximum results.

Содержание

Скачать