Yamaha ns-c700 [4/24] Attaching the front cover

2 En

■ How to connect

1 Loosen the knob.

2 Remove 10 mm (3/8”) of insulation from each end of the

cables, and twist the exposed conductors together neatly and

tightly, as shown below.

3 Insert the bare wire.

4 Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on the

cables at the terminal.

Notes

• Do not let the bare speaker wires touch each other as this

could damage the speaker or the amplifier, or both.

• Do not insert the insulation into the hole. Sound may not be

produced.

■ When using a banana plug

Note

Do not take off this cover unless using a banana plug.

1 Tighten the terminal knob.

2 Remove the cover by pulling it toward you.

3 Simply insert the banana plug into the terminal.

Note

Use a suitable instrument to remove the cover. Removing it

with your bare hands may hurt your fingertips.

The speaker and the front cover are packed separately. To attach

the front cover, line up the projections (magnets) on the reverse

side of the front cover with their corresponding screw heads on the

speaker.

Notes

• When removing the cover, be careful that you don’t touch

the drive units, and don’t exert excessive force with any

tools.

• There are magnets on the reverse side of the front cover. Do

not place a front cover close to objects that might be affected

by magnets, such as TV, clock, magnetic card, diskette, etc,

after removing it.

Good No Good

10 mm

(3/8 ”)

Banana plug

Cover

ATTACHING THE FRONT

COVER