Graco HG6000 [3/20] Warnings

Warnings

309834T 3

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-

tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When

these symbols appear in the body of this manual, refer back to these Warnings. Product-specific hazard symbols and

warnings not covered in this section may appear throughout the body of this manual where applicable.

WARNING

EQUIPMENT MISUSE HAZARD

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

• This equipment is for professional use only.

• Use the equipment only for its intended purpose. Call your Graco distributor for information.

• Read all instruction manuals, tags, and labels before operating equipment.

• Check equipment daily. Repair or replace worn or damaged parts immediately.

• Do not alter or modify this equipment. Use only Graco parts and accessories.

• Do not exceed the maximum working pressure of the lowest rated system component.

• Be sure that all spray/dispensing equipment and accessories are rated to withstand the maximum

working pressure of the pump. Do not exceed the maximum working pressure of any component or

accessory used in the system.

• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

• Do not exceed the maximum temperature rating of any system component.

• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all

equipment manuals. Read fluid and solvent manufacturer’s warnings.

• Always wear protective eyewear, gloves, clothing, and respirator as recommended by the fluid and

solvent manufacturer.

• Comply with all applicable local, state, and national fire, electrical, and safety regulations.

FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD

Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and

result in fire or explosion and serious injury.

• Ground the equipment and the object being dispensed.

• Do not use this equipment with flammable liquids.

• Keep the dispense area free of debris, including solvent, rags, and gasoline.

• If there is any static sparking or you feel an electric shock while using the equipment, stop dispens-

ing immediately. Do not use the equipment until you have identified and corrected the problem.

• Be sure all electrical work is performed by a qualified electrician only.

• Have any checks, installation, or service to electrical equipment performed by a qualified electrician

only.

• Be sure all electrical equipment is installed and operated in compliance with applicable codes

• Be sure power is disconnected when servicing and repairing equipment

• Before operating the equipment, extinguish all open flames or pilot lights in the dispense area

• Do not smoke in the dispensing area.

• Keep liquids away from the electrical components

• Disconnect electrical power at the main switch before servicing the equipment.