Moxa EDS-P506A-4PoE-SS-SC-T [10/15] Turbo ring dip switch settings

Moxa EDS-P506A-4PoE-SS-SC [10/15] Turbo ring dip switch settings
- 10 -
Wiring the Digital Inputs
The EDS-P506A-4PoE has two sets of digital inputs, DI 1 and DI 2. Each
DI consists of two contacts of the 6-pin terminal block connector on the
EDS-P506A-4PoE’s top panel, which are used for the two DC inputs. The
top and front views of one of the terminal block connectors are shown
here.
STEP 1: Insert the negative
(ground)/positive DI wires into
the
/I1 terminals, respectively.
STEP 2
: To keep the DI wires
from pulling loose, use a small
flat
-blade screwdriver to tighten
the wire
-clamp screws on the
front of the terminal block
connector.
STEP 3
: Insert the plastic
terminal block connector prongs
into the terminal block receptor,
which is loc
ated on the
EDS-P506A-4PoE’s top panel.
Turbo Ring DIP Switch Settings
EDS-P506A-4PoE switches are plug-and-play managed redundant
Ethernet switches. The proprietary Turbo Ring protocol was developed by
Moxa to provide better network reliability and faster recovery time. Moxa
Turbo Rings recovery time is less than 300 ms (Turbo Ring) or 20 ms
(Turbo Ring V2) compared to a 3- to 5-minute recovery time for
commercial switchesdecreasing the possible loss caused by network
failures in an industrial setting.
There are 4 Hardware DIP Switches for Turbo Ring on the top panel of
EDS-P506A-4PoE that can help setup the Turbo Ring easily within
seconds. If you do not want to use a hardware DIP switch to setup the
Turbo Ring, you can use a web browser, telnet, or console to disable this
function.
NOTE
Refer to the Turbo Ring DIP Switch section and Using
Communication Redundancy
section in the User’s Manual for
detailed information about the settings and usage of Turbo Ring
and Turbo Ring V2.
EDS-P506A-4PoE Series DIP Switches
The default setting for each DIP Switch is OFF. The
following table explains the effect of setting the DIP
Switch to the ON position
.

Похожие устройства

Скачать