![Moxa TC-6110-T-W7E [17/46] Attention](/img/pdf.png)
Moxa TC-6110-T-W7E [17/46] Attention
![Moxa TC-6110-T-W7E [17/46] Attention](/views2/1200316/page17/bg11.png)
TC-6110 Series Hardware Hardware Installation
2-7
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your device.
Caution!
High Electrical Current!
Calculate the maximum possible current
for the diameter of each power wire and common wire. Observe all
electrical codes dictating the maximum current allowable for each wire
gauge.
If the current goes
above the maximum ratings the wiring could overheat, causing serious damage to your
equipment.
Caution! High
Temperatures!
Be careful when handling the unit. When the unit is plugged in, the internal components generate
a lot of
heat
which may leave
the outer casing too hot to safely touch with bare hands.
Connecting the Power Supply
The TC
-6110 computers come with dual (redundant) DC power inputs,
24 to 110
volts each
(variable). Refer to the figure at right
for the power pin assignment of
the power
inputs.
When setting up
TC-6110 computers for testing and/or system development
in an
office or lab with an AC source
, follow these steps to connect the AC power
adaptor
:
Step 1: Connect the exposed ends of the extended power switch cable to the male portion of the 2-pin
Euroblock (provided).
Step 2: Plug the male Euroblock into the matching female terminal on the front panel.
Step 3: Make sure the power switch is turned off (Open, in the diagram below).
Step 4: Connect the earth/ground cable to the Phillips-head ground connector on the lower right corner of the
front panel.
Step 5:
Connect the power cable (CBL-
Power Jack to M12) to the M12 connector
as shown at right. Then connect the power
connector to power input 1 on the front
panel.
Step 6:
On the other side of the power cable, connect to the PWR-24250-DT-
S1
power adaptor (optional), and a PWC
-series power cord (optional).
Step 7: To check power redundancy, use the same method to connect the power to the power input 2.
Step 8: Switch on the TC-6110 (Short state). If power supply is connected properly, both power input and
system power LEDs will be on (green), as well as the yellow Ready LED.
Содержание
- Edition 5 march 2016 1
- Tc 6110 series hardware manual 1
- Www moxa com product 1
- Copyright notice 2
- Disclaimer 2
- Tc 6110 series hardware manual 2
- Technical support contact information 2
- Trademarks 2
- Www moxa com support 2
- Introduction 4
- Model descriptions and package checklist 5
- Overview 5
- Tc 6110 series hardware introduction 5
- Appearance 6
- Tc 6110 series hardware introduction 6
- Computer 7
- Features 7
- Hardware specifications 7
- Led indicators 7
- Reset button 7
- Storage 7
- Tc 6110 series hardware introduction 7
- Display 8
- Ethernet interface 8
- Gps module 8
- Other peripherals 8
- Serial interface 8
- Serial signals 8
- Tc 6110 series hardware introduction 8
- Wlan module available on request 8
- Environmental limits 9
- Mtbf mean time between failures 9
- Physical characteristics 9
- Reliability 9
- Standards and certifications 9
- Tc 6110 series hardware introduction 9
- Warranty 9
- Hardware block diagram 10
- Tc 6110 series hardware introduction 10
- Hardware installation 11
- Desktop 12
- Mounting 12
- Rack mounting 12
- Tc 6110 series hardware hardware installation 12
- Attentions 13
- Tc 6110 series hardware hardware installation 13
- Optional rack panel extender installation 14
- Tc 6110 series hardware hardware installation 14
- Tc 6110 series hardware hardware installation 15
- Attention 16
- Tc 6110 series hardware hardware installation 16
- Wiring requirements 16
- Attention 17
- Connecting the power supply 17
- Tc 6110 series hardware hardware installation 17
- Attention 18
- Tc 6110 series hardware hardware installation 18
- Connecting audio input output 19
- Connecting to a display 19
- De 15 female connector 19
- Tc 6110 series hardware hardware installation 19
- Connecting usb devices 20
- Tc 6110 series hardware hardware installation 20
- Connecting serial devices 21
- Lan ports 21
- Tc 6110 series hardware hardware installation 21
- Installing the ssd hdd into the storage tray 22
- Tc 6110 series hardware hardware installation 22
- Tc 6110 series hardware hardware installation 23
- Tc 6110 series hardware hardware installation 24
- Replacing the battery 25
- Tc 6110 series hardware hardware installation 25
- Tc 6110 series hardware hardware installation 26
- Tc 6110 series hardware hardware installation 27
- Installing system memory and cf card 28
- Tc 6110 series hardware hardware installation 28
- Tc 6110 series hardware hardware installation 29
- Bios setup 30
- Bios main page 31
- Entering the bios setup utility 31
- Tc 6110 series hardware bios setup 31
- Advanced settings 32
- Boot configuration 32
- Modifying bios settings 32
- Ide configuration 33
- Peripheral configuration 33
- Tc 6110 series hardware bios setup 33
- Tc 6110 series hardware bios setup 34
- Video configuration 34
- Acpi table features control 35
- Tc 6110 series hardware bios setup 35
- Usb configuration 35
- Hardware monitor 36
- Tc 6110 series hardware bios setup 36
- Security settings 37
- Set all hdd password 37
- Set supervisor password 37
- Set user password 37
- Tc 6110 series hardware bios setup 37
- Warning 37
- Advanced cpu control 38
- Ht support hyper threading technology 38
- Power settings 38
- Set all master hdd password 38
- Thermal mode 38
- Boot settings 39
- Pxe boot to lan 39
- Quick boot 39
- Uefi boot 39
- Use xd capability 39
- Exit settings 40
- Legacy 40
- Tc 6110 series hardware bios setup 40
- Usb boot 40
- Discard changes 41
- Exit discarding changes 41
- Exit saving changes 41
- Load custom defaults 41
- Load defaults setting 41
- Save change without exit 41
- Save custom defaults 41
- Tc 6110 series hardware bios setup 41
- Attention 42
- Tc 6110 series hardware bios setup 42
- Upgrading the bios 42
- C cd tc6110 43
- S05 exe 43
- Tc 6110 series hardware bios setup 43
- Attention 44
- Tc 6110 series hardware bios setup 44
- A rtc battery warning 45
- B fuse warning 45
- C rack mount warning 45
- D high temperature warning 45
- Safety installation instructions 45
- Regulatory statement approval 46
Похожие устройства
- Moxa TC-6110-T-W7E Технические характеристики
- Moxa TC-6110-T-W7E Руководство по быстрой установке
- Moxa TC-6110-T-W7E Руководство по программной части (Linux)
- Moxa TC-6110-CT-LX Инструкция по эксплуатации
- Moxa TC-6110-CT-LX Руководство по аппаратной части
- Moxa TC-6110-CT-LX Технические характеристики
- Moxa TC-6110-CT-LX Руководство по быстрой установке
- Moxa TC-6110-CT-LX Руководство по программной части (Linux)
- Moxa TC-6110-CT-T-LX Инструкция по эксплуатации
- Moxa TC-6110-CT-T-LX Руководство по аппаратной части
- Moxa TC-6110-CT-T-LX Технические характеристики
- Moxa TC-6110-CT-T-LX Руководство по быстрой установке
- Moxa TC-6110-CT-T-LX Руководство по программной части (Linux)
- Moxa TC-6110-CT-W7E Инструкция по эксплуатации
- Moxa TC-6110-CT-W7E Руководство по аппаратной части
- Moxa TC-6110-CT-W7E Технические характеристики
- Moxa TC-6110-CT-W7E Руководство по быстрой установке
- Moxa TC-6110-CT-W7E Руководство по программной части (Linux)
- Moxa TC-6110-CT-T-W7E Инструкция по эксплуатации
- Moxa TC-6110-CT-T-W7E Руководство по аппаратной части