M-Audio Delta TDIF Инструкция по эксплуатации онлайн [22/58] 19006

1. The default setting, "WavOut 1/2", connects TDIF ports OUT1 and OUT2 to

your music software or Windows multimedia applet. In other words, when

music software plays audio to the device named "WavOut 1/2 Delta-TDIF" it

will be routed directly to the "hardware" TDIF outputs 1 & 2 of your TDIF 25-

pin connector.

2. The second option, "Monitor Mixer", connects TDIF ports OUT1 and OUT2 to

the outputs of the Delta TDIF monitor mixer. For more information of the

capabilities of the monitor mixer, please see the section "Monitor Mixer Page".

3. The third option, "SP/ANA In", connects TDIF ports OUT1 and OUT2

directly to the hardware Analog or S/PDIF inputs on the Delta TDIF PCI host

card (whichever input is selected in the Hardware Settings page will be the

active input). The left channel of the S/PDIF In is routed to OUT1 and the

right channel of the S/PDIF In is routed to OUT2.

4. The fourth option, "SP/ANA In (L/R Rev.)", functions identically to the third

option, except that the left and right channels are swapped. Therefore in this

mode, the left channel of the Analog or S/PDIF input (as selected in the

Hardware Settings page) is routed to OUT2 and the right channel of the

Analog or S/PDIF input is routed to OUT1.

5. Selections five through eight connect the hardware TDIF inputs 1 & 2, 3 & 4,

5 & 6, or 7 & 8 (respectively) directly to the Delta card’s hardware TDIF

outputs 1 & 2. For example, if "H/W In 1/2" were selected, any signal present

at the IN1 port will be copied to OUT1, and any signal present at the IN2 port

will be copied to OUT2. This same behavior applies to "H/W In 3/4", "H/W

In 5/6", and "H/W In 7/8" when selected.

The next three vertical columns of the Patchbay/Router page (from left to

right), "H/W Out 3/4," "H/W Out 5/6," and "H/W Out 7/8," connect these

hardware TDIF outputs to one of seven sources. Since the three columns

function identically, we’ll use "H/W Out 3/4" as the example:

1. The default setting, "WavOut 3/4", connects TDIF ports OUT3 and OUT4

to your music software or Windows/Macintosh multimedia applet. In

other words, when music software plays audio to the device named

"WavOut 3/4 Delta-TDIF" it will be routed directly to the "hardware" TDIF

outputs 3 & 4 of your TDIF 25-pin connector.

2. The second option, "SP/ANA In", connects TDIF ports OUT3 and OUT4

directly to the hardware Analog or S/PDIF input on the Delta TDIF PCI

host card (whichever input is selected in the Hardware Settings page will

be the active input). The left channel of the S/PDIF input is routed to

OUT3 and the right channel of the S/PDIF input is routed to OUT4.

3. The third option, "SP/ANA In (L/R Rev.)", functions identically to the

second option, except that the left and right channels are swapped.

Therefore in this mode, the left channel of the Analog or S/PDIF input is

routed to OUT4 and the right channel of the Analog or S/PDIF input is

routed to OUT3.