M-Audio Delta RBUS Инструкция по эксплуатации онлайн [29/60] 19013

or pops in the audio stream as some data may be lost. Larger buffers

cause slightly more latency but prevent the pops and clicks that might

occur with smaller buffer sizes – the default settings are recommended

but you may desire to tweak these default settings to suit your tastes.

This buffer size must be set in the Delta Control Panel before you launch

your music software. When using ASIO with the Delta R-BUS, set the

buffer size in the control panel, then exit the control panel. After doing so,

launch your music software.

VARIABLE OUTPUT LEVELS

The software switches in this section allow the user to match the Delta

R-BUS’ analog output levels to the operating signal levels of the external

audio equipment. Two level selections are available: ‘Consumer,’ and

–10dBV. The ‘Consumer’ setting is the least ‘sensitive’ of the two settings,

and ‘–10dBV’ the most sensitive. Therefore, the ‘Consumer’ setting has

more headroom and can accept the hotter signals of the two settings.

Consult the user guide of your external audio equipment regarding your

equipment’s input line level.

INPUT AUDIO SOURCE

The Delta R-BUS breakout cable includes inputs for both analog and S/PDIF

connections. However, only one of these inputs, either Analog or S/PDIF, may

be selected and used at one time. This section provides a software switch that

allows you to select between “SP/ANA Ports.” Selecting “S/PDIF” makes the

S/PDIF hardware input the active input. Selecting “Analog” makes the the

analog hardware inputs active. Remember that when S/PDIF is selected as the

Input Audio Source, “S/PDIF In” must be selected as the master clock,

otherwise no signal can be properly recorded at the S/PDIF input.

“DISABLE CONTROL” CHECKBOX

When running a music program that utilizes the Delta ASIO drivers, the

music program will take control of some of the Delta Control Panel

functions. Checking this checkbox will “Disable Control of the Monitor

Mixer and Patchbay/Router in Audio Applications,” namely, these ASIO

capable applications. Some programs interpret Direct Monitoring

differently, and may result in undesirable configurations for monitoring.

Emagic’s Logic program, in particular, will switch the Patchbay/Router

into “Monitor Mixer” mode when Logic is switched into record. You may

want to click on this switch when using Logic , thereby disengaging its

control over the Patchbay/Router.

ON THE MAC: The Hardware Settings Page in the Macintosh version of

the Delta Control Panel also contains software switches that allow you to

select which Delta input and output stereo pair will be used by the Sound