M-Audio Delta RBUS Инструкция по эксплуатации онлайн [37/60] 19013

If recording from the S/PDIF output, make sure the S/PDIF output

format is correct. Open the S/PDIF page of the control panel software.

Under Digital Output Format, choose "Consumer." Uncheck "Advanced"

if it is checked previously. Now click on the "Restore Defaults" button to

set the default S/PDIF outgoing status bits. This will disable copy

protection and also set the emphasis to "none," allowing the DAT to

accept and record the audio properly.

Transferring from Computer to Roland R-BUS,

monitoring with Analog Outs

1. Connect the Delta R-BUS’s 25-pin R-BUS connector to the Roland

multitrack’s R-BUS connector using an R-BUS cable.

2. Connect the Delta R-BUS’s analog outputs to some type of amplified

sound system. The sound system should be equipped with speakers

or headphones. Set the line level switch in the Hardware Settings

page for the analog outputs to be compatible with that sound system’s

inputs (see section “Hardware Settings Page”).

3. Because you will be playing back at the recorded sample rate, you will

want to set the Delta R-BUS’s master clock to use the internal crystal.

Do this by opening the Hardware Settings page of the Delta Control

Panel software and under Master Clock, select "Internal Xtal." Also,

under the Codec Sample Rate section you may uncheck "Rate Locked"

if it is previously checked. This allows for more flexible sample rate

playback. Consequently, you will need to set up your Roland

multitrack to receive external sync, since the Delta R-BUS is now the

master clock.

Roland