Moxa VPort P26A-1MP [21/82] Software installation

Moxa VPort 26A-1MP Getting Started

2-7

NOTE

After adjusting the PAN, TILT, and ROTATE positions, tighten all

of the screws to ensure that the or

ientation of

the camera does

not change.

d) Zoom adjustment

To adjust the Zoom and Focus positions, connect to the camera’s web console first so that you can view a live

video feed. Next, loosen the screws for both the zoom and focus positions, and then rotate the lens to focus on

the desired image. Finally, tighten both screws.

NOTE

To adjust the focus position, loosen the appropriate screw and

then rotate the lens head.

Step 7: Fasten the upper case to the bottom case to complete the hardware

installation.

Software Installation

Step 1: Configure the VPort 26A-1MP’s IP address

When the VPort 26A-1MP is first powered on, the POST (Power On Self Test) will run for a few moments. The

System LED will turn green when the POST is complete. The 10 Mbps or 100 Mbps LED will then flash as the IP

address is assigned. The network environment determines how the IP address is assigned.

Network Environment with DHCP Server

For this network environment, the unit’s IP address will be assigned by the network’s DHCP server. Refer to the

DHCP server’s IP address table to determine the unit’s assigned IP address. You may also use the Moxa VPort

and Ether Device Configurator Utility (edscfgui.exe), as described below:

Using the Moxa VPort and EtherDevice Configuration Utility (edscfgui.exe)

1. Run the edscfgui.exe program to search for the VPort device. After the application window opens, click on

the Search button to initiate a search.

2. When the search has concluded, the VPort’s Model Name, MAC address, IP address, serial port, and HTTP

port should be listed in the utility’s window.