M-Audio DMP3 [7/10] Hi lo gain switches

DMP3 | User Guide

Hi/Lo Gain Switches

Two gain ranges are provided for the DMP3 preamps. The “Hi/Lo Gain” switch on the

front panel is used to select between the two gain ranges, with the ‘Out’ position being

the default.

The Hi/Lo Gain switch in the Out position is the “Hi Gain” range, while the ‘In’ position

switches the DMP3 to the “Lo Gain” range. The gain range is considered to be from

the beginning to the end of the Gain Adjustment Knob’s travel from left to right. In the

Out, or Hi Gain position, the DMP3 preamp of the corresponding channel will provide

32dB to 66dB of gain using either the microphone inputs or the 1/4” high impedance

instrument inputs. In the In, or Lo Gain position, the DMP3 preamp (of the

corresponding channel) will provide 6dB to 40dB of gain using the microphone or 1/4”

high impedance instrument inputs.

Some mics or instruments will have a hotter output signal than others. As a general guideline,

if you use a mic or instrument in the Hi Gain position and find that you can achieve a

desirable output level with the Gain Adjustment Knob set somewhere between 10:00 and

2:00 (or higher if necessary), then the Hi Gain position is a proper choice. If, however, you

find yourself clipping while hardly any movement of the Gain Adjustment Knob has been

made, then switching to the Lo Gain position is advised. Conversely, if you are in the Lo Gain

position and find that you have to turn the Gain Adjustment Knob past 2:00, then you might

want to try lowering the gain and switching to the Hi Gain position.

Low-Cut Rumble Filter

When foot movements, mic stand noise, or other low frequency sounds are unwanted,

use the DMP3 Low-Cut filter to reduce or remove them. The DMP3 uses a 3-pole filter,

attenuating the signal 75Hz and below at the rate of 18dB per octave.

A “Low Cut” switch is provided on the front panel of the DMP3. Pressing and locking

this switch to the ‘In’ position will engage the low pass filter, indicated by the lit low cut

filter LED.

Phase Inversion

It is possible, with a stereo configuration (2-channel) or when two microphones are

recording one instrument, for the two signals to become "out of phase" with each

other. When similar signals are out of phase, they tend to cancel each other out,

greatly reducing signal level. Engaging just one of the DMP3 Phase Inversion switches

will remedy this situation. If you suspect that your two channels are out of phase, simply

switch phase reverse for one of the channels and see if the sound suddenly ‘comes

alive.’