D-Link DWL-3600AP [18/128] Configuring the ethernet settings

Unied Access Point Administrator’s Guide

Page 18

October 2013

Section 2 - Getting Started

Figure 4 - Command Line Interface (CLI) Connection

Conguring the Ethernet Settings

The default Ethernet settings, which include DHCP and VLAN information, might not work for all networks.

By default, the DHCP client on the UAP automatically broadcasts requests for network information. If you want to

use a static IP address, you must disable the DHCP client and manually congure the IP address and other network

information.

The management VLAN is VLAN 1 by default. This VLAN is also the default untagged VLAN. If you already have

a management VLAN congured on your network with a different VLAN ID, you must change the VLAN ID of the

management VLAN on the access point.

For information about using the Web interface to congure the Ethernet settings, see “Ethernet Settings” on page

35. You can also use the CLI to congure the Ethernet settings, which the following section describes.

Using the CLI to Congure Ethernet Settings

Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For more

information about each setting, see the description for the eld in the following table.

Action Commands

Get the DNS Name

get host id

Set the DNS Name

set host id <host_name>

For example:

set host id lab-ap

Get Current Settings for the Ethernet (Wired) Internal

Interface

get management

Set the management VLAN ID

set management vlan-id <1-4094>

View untagged VLAN information

get untagged-vlan

Enable the untagged VLAN

set untagged-vlan status up

Disable the untagged VLAN

set untagged-vlan status down

Set the untagged VLAN ID

set untagged-vlan vlan-id <1-4094>

View the connection type

get management dhcp-status