M-Audio Omni i/o Инструкция по эксплуатации онлайн [20/30] 19296

1. Launch your music software, then select a track for recording.

2. Choose the proper Delta input as the source for that track.

3. Enable the track for recording.

10.1 Monitoring the Signals You Are Recording

We’ve spoken about listening to the playback of recorded audio files while the

Delta Patchbay/Router is set to the “software” outputs. Only certain music

software allows you to use that setting to monitor the signals you are recording.

See the next section, 10.2, for more info on monitoring the record channels using

the software ouputs (Patchbay /Router “WavOut” (PC) or “SM/ASIO Out”

(Mac) settings), which applies when using the Delta ASIO or EASI drivers.

The Patchbay/Router in the Delta Control Panel allows you to monitor the

record inputs (Delta H/W Ins) in two other fashions. You may select the H/W

Ins as your monitoring source for the H/W Outs. Or, you may select the Monitor

Mixer as the source in the Patchbay/Router page, and then bring up and unmute

the fader(s) assigned to “H/W In.” Here are some suggestions for monitoring

setups along those lines. Once you have chosen your setup, refer to section 10.3,

“Setting Record Levels.”

NOTE: The Omni I/O runs at a +4dB line level. We suggest leaving

the Variable Signal Level in the Delta panel’s Hardware Settings

page to +4 for the Delta Outs. If this setting causes your sound

system or mix deck to distort, try a lower setting.

A. When recording using the Mic/Instr Ins:

1. In the Delta panel’s Patchbay/Router page, set H/W Out 1/2 to “Monitor

Mixer” (make sure that H/W Out 3/4 is set to “WavOut 3/4”).

2. In the Delta panel’s Monitor Mixer page, unmute the channels for H/W In

1/2. Raise the faders to all the way to full level (this setting will not affect

record levels). You will later use these faders to adjust listening level after

“Setting Record Levels” in section 10.3. Pan each channel as desired (if these

are mono instruments, you might want to pan them to the center).

3. In the Monitor Mixer page, unmute the channels for H/W Out 1/2, and

raise the faders to full level.

4. Set the audio track’s source in your music software according to the chart in

section 10. Set the same track’s output ports to WavOut Delta 1/2 (or ASIO

Out 1 and 2), and pan them in a fashion similar to the inputs in your

Monitor Mixer page.