Aten CS82A [10/20] Installation

- 10 -

Installation

To set up your CS-82A / CS-84A installation, refer to the

installation diagram on the next page (the numbers in the

diagram corresponds to the steps, below), and do the following:

1. Plug your PS/2 keyboard, and PS/2 mouse into the Console

ports located on the unit’s front panel.

2. Plug your monitor into the Console port located on the unit’s

back panel.

3. Using the Custom KVM cable sets provided, plug the monitor,

keyboard, and mouse connectors into the KVM Port sections

of the CS-82A / CS-84A.

4. At the other end of the cable, plug the corresponding monitor,

keyboard, and mouse connectors into their respective ports

on the computers you are connecting.

Note: Verify that all plugs are in the same KVM Port sockets (all

in Port 1, all in Port 2, etc.). Each socket is marked with an

appropriate icon.

5. If you choose to use external power (which is optional if your

installation does not exceed 10 m), plug the power adapter

into an AC power source, then plug the power adapter cable

into the CS-82A / CS-84A’s power jack.

6. Turn on the power to the computers.

Note: The CS-82A / CS-84A’s Power On default is to link to the

first computer you turn on.

1. Make sure that the power to any device that you

connect to the installation has been turned off. You

must unplug the power cords of any computers that

have the Keyboard Power On function.

2. Make sure that all devices you will be installing are

properly grounded.