AEG mc 4463 [31/38] General operation

AEG mc 4463 [31/38] General operation
English
31
• RemovethetransportprotectionfromtheCDplayer
if present before use.
General Operation
NOTE:
• Somebuttonsaretobefoundbothonthedevice
itself and on the remote control. Buttons with the same
designation have the same function.
• Operationoftheunitisdescribedbythebuttonsofthe
remote control.
Infrared remote control
Forwirelesscontrolatadistanceofapprox.4meters.Ifthis
range decreases, the batteries must be replaced. During
use, ensure that there are no obstacles between the remote
control and the sensor (4) on the unit.
Turning the unit on/off
• Pressthe STANDBYbutton(23),toturntheuniton.
• Pressthe
STANDBYbuttonagaintoturntheunitoff.
The power indicator lamp (10) lights up.
NOTE:
Afterapprox.15minuteswithoutasignalorifthesignalis
too weak, the unit will automatically switch to standby.
Volume
YoucanusetheVOL+/VOL-buttons(5)tosetthedesired
volume.
MUTE (1)
Quickly turn off the sound. The indication “MUTE” appears
in the display. To cancel this function, press
MUTE again.
EQ (13)
(Preset equalizer function). There are different sound modes
available(FLAT,ROCK,CLASSIC,JAZZ,POP).
Setting the sleep timer
When the sleep timer has been set, the unit is switched off
after a preset time. Press the SLEEP button (14) to activate
the sleep timer. By repeatedly pressing the SLEEP button, the
off time can be set as 90, 80, 70, 60, 50, 40, 30, 20, 10 minutes.
To turn off the sleep timer, press the SLEEP button until the
symbol “SL” on the display goes out. “S - 00” appears in the
display for a short amount of time.
Listening to the Radio
Find stations
1. PresstheSOURCEbutton(8),untilFMshowsinthe
display.AlternativelyyoucanalsopresstheFMbutton
(7) to select radio mode.
2. Use the buttons TUN+ (6) and TUN- (19) to tune to the
desired station. When you hold down either button, the
unittunestothenextradiostation.Thedisplayshowsthe
tuned frequency.
3. In case the reception is too weak and if the received
station has atmospheric noise, you will have the following
possibilities:
a) Switch the device to Mono operation. Press the ST/
MONO button (11) to do so. The stereo indicator “ST”
lights up on the display.
b) Try to improve the reception through a position
change or through coiling in and out of the antenna.
Save radio stations
The unit can store up to 30 radio stations. To store a station,
proceed as follows:
1. Find a station as described in “Find stations”.
2. PresstheMEMORYbutton(12).Thedisplaystartsash-
ing.
3. Use the buttons
and (5) to select the memory
where the station is to be stored.
4. PresstheMEMORYbuttonagain.Thestationisstored
andthedisplaystopsashing.
Call a stored radio station
• Youcancallthestoredradiostationswiththenumber
buttons (2). For stored radio stations above 10, first press
the 10+ button.
• Alternatively,youcanalsousethebuttons
and
(5).
Automatic scanning
BrieyholddowntheAUTO/STOPbutton(9).Withthis,the
entire frequency range is scanned automatically for stations.
The stations found by scanning are stored in ascending order
in the memory locations 1 to 30.
NOTE:
The sequence cannot be changed afterwards. The preset
radio stations will be lost.
Playing CDs/MP3
This is how you play a CD
1. PresstheSOURCEbutton(8)untildISCshowsinthe
display.AlternativelyyoucanalsopresstheCDbutton(17)
to select CD mode.
2. In order to open the CD compartment (1), press the
PUSH button.
3. Insert an audio CD with the printed side facing upwards
on to the central cone so that the CD clicks into place and
then close the lid of the CD compartment. The message
“rEAd”willbeshownonthedisplayforashorttime.
For an audio CD: The total number of tracks and the
playing time of the CD is shown.

Содержание

Скачать
Случайные обсуждения

Ответы 1

Как выключить радио?
4 года назад