GBC Fusion 1100L, A3 [6/76] Getting ready to laminate

GBC Fusion 1100L, A3 [6/76] Getting ready to laminate
GB
6 register this product online at www.accoeurope.com
getting ready to laminate
Easy Set Up
1 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
2 The laminator will respond with a single beep and a sequence of brief ashes across the control
panel.
3 To use the laminator move the slider to the right from the
’ to the 75 mic or 125 mic position
depending on which pouch selected. Below the slider you will see a white line, this indicates that
you have switched the laminator on.
loading the pouch
1 Take your item to be laminated and place in to the appropriate sized laminating pouch,
ensuring it is rmly located along the sealed edge. This is to help ensure that you get optimal
quality output.
Before laminating important or unique documents, always run a test pouch through
the laminator using a similar type document.
SEALED EDGE
A3, A4, A5, etc. Irregular shaped item
SEALED EDGE
NOTE: Do not cut pouches prior to
lamination.
a b
NOTE: Your new laminator may emit a slight
odour during the initial operation. Its
is normal and will diminish after a few
hours of operation.
NOTE: only use 75micron/80 micron, 100
micron or 125 micron pouches with
this laminator.
Visual & Audible Ready Alerts
4 The laminator will start to warm up - an orange light will be illuminated to the right of the
(a).
When the laminator is ready to use the green light next to the ‘tick is illuminated (b) and a
series of two beeps are heard.

Содержание