Hama ews-165 h-92659 [2/32] G operating instruction
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hama ews-165 h-92659 [2/32] G operating instruction

Hama ews-165 h-92659 [2/32] G operating instruction
2
3
G Operating instruction
A
B
20
21
23
22
28
24
25
26
27
8
9
10
12
16
19
11
13
15
18
1
2
4
5
7
14
17
3
6
Controls and Displays
A Base station
1. Measuring station wireless symbol
2. Channel display
3. Outdoor temperature
4. Room temperature
5. Wireless symbol
6. Time zone
7. Day
8. Outdoor temperature trend
9. Room temperature trend
10. Time
11. Weekday / seconds
12. Alarm symbol
13. Month
14. button
= reducing the current setting / manually searching for
the signal from the measuring station
15. CHANNEL button
= channel selection
16. ▲ button
= increasing the current setting / activating/ deactivating
manual radio signal reception
17. MODE button
= Einstellungen / Bestätigung des Einstellungswerts
/ Wechsel zwischen Sekunden-, Wochentag- und
Zeitzonenanzeige
18. ALARM ON/OFF button
= display / setting alarm modes
19. MEM button
= accessing/ resetting the stored maximum/minimum
values
20. SNOOZE button
= stops the alarm
21. Opening for wall mounting
22. Base
23. Battery compartment
B Measuring station
24. Battery compartment
25. Mounting plate
26. Cut-out for vertical mounting
27. Cut-out for horizontal mounting
28. Clips
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specic hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
•Weather station EWS-165
(base station for indoor/outdoor measuring station)
•Base
•2x AAA batteries
•2x AA batteries
•These operating instructions
3. Safety Instructions
•The product is intended for private, non-commercial use
only.
•Do not operate the product outside the power limits given
in the specications.
•Do not use the product in moist environments and avoid
splashes.
•Do not use the product in the immediate vicinity of heaters
or other heat sources or in direct sunlight.
•Do not use the product in areas where the use of electronic
devices is not permitted.
•Do not place the product near interference elds, metal
frames, computers, TVs, etc. Electronic devices and window
frames can negatively affect the product’s functionality.
•Do not drop the product and do not expose it to any
major shocks.
•Do not open the device or continue to operate it if it
becomes damaged.
•Do not attempt to service or repair the product yourself.
Leave any and all service work to qualied experts.
•Keep the packaging material out of the reach of children
due to the risk of suffocation.
•Dispose of packaging material immediately according to
locally applicable regulations.
•Do not modify the product in any way. Doing so voids the
warranty.
Warning – Batteries
•Immediately remove and dispose of dead batteries from
the product.
•Only use batteries (or rechargeable batteries) that
match the specied type.
•Do not mix old and new batteries or batteries of a
different type or make.
•When inserting batteries, note the correct polarity (+
and - markings) and insert
the batteries accordingly. Failure to do so could result in
the batteries leaking or exploding.
•Do not charge batteries.
•Keep batteries out of the reach of children.
•Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.
4. Getting Started
4.1. Inserting the batteries
Measuring station
•Open the battery compartment (24) and remove the
contact breaker. Replace the battery compartment cover.
Base station
•Open the battery compartment (23) and remove the
contact breaker. Replace the battery compartment cover.
4.2. Replacing the batteries
Measuring station
•Open the battery compartment (24), remove and properly
dispose of the dead batteries and insert two new AAA
batteries with the correct polarity. Replace the battery
compartment cover.
Base station
•Open the battery compartment (23), remove and properly
dispose of the dead batteries and insert two new AA
batteries with the correct polarity. Replace the battery
compartment cover.
Note
Before use, ensure you insert the batteries in the
measuring station rst and then in the base station.
5. Installation
Note – Installation
•We recommend initially placing the base and
measuring stations in the intended locations without
installing them and making all the settings described in
6. Operation – to do.
•Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.
Note
•The wireless transmission range between the measuring
and base stations is up to 30 m in open spaces.
•Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
•Before the nal installation, ensure that there is
sucient reception between the intended installation
locations.
•When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
•The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
•Buy special or suitable installation material from a
specialised dealer for wall-mounting.
•Ensure that no faulty or damaged parts are installed.
•Never apply force during installation. This could
damage the product.
•Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.

Содержание

Похожие устройства

Скачать