Hama ews-165 h-92659 Инструкция по эксплуатации онлайн [4/32] 182636

Hama ews-165 h-92659 Инструкция по эксплуатации онлайн [4/32] 182636
6
7
6.4. Weather
•The weather station indicates a trend as to how the values
for the outdoor temperature (8), room temperature (9) are
likely to develop over the next few hours.
Display Trend
Increasing
Constant
Decreasing
6.5. Maximum and minimum temperature values
•The base station automatically stores the maximum and
minimum outdoor/indoor temperature.
•Repeatedly press the MEM button (19) to switch between
the current temperature, minimum temperature (MIN)
and maximum temperature (MAX). The maximum and
minimum temperatures are displayed for 10 seconds.
•Press and hold the MEM button (19) for approx. 3 seconds
to reset the stored maximum and minimum values.
6.6 Low battery capacity
Measuring station
If the batteries need to be replaced, the symbol for low
battery charge will appear next to the outdoor
temperature display on the base device. Replace the batteries
immediately.
Base station
If the batteries need to be replaced, the symbol for low
battery charge will appear next to the time display on
the base device. Replace the batteries immediately.
Note Replacing the batteries
•Note that the stations have to be resynchronised each
time after you change the batteries in the measuring
or base station.
•To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents. Make sure that
water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
10. Technical Data
Base station
Measuring station
Power supply
3,0 V
2 x AA batteries
3,0 V
2 x AAA batteries
Measuring range
Temperature
-5°C +50°C/
23°F 122°F
-10°C +60°C/
14°F 140°F
Measurement
increments
Temperature
0,1°C / 0,2°F 0,1°C / 0,2°F
Temperature
measurement
cycle
~ 45 s~45 s
Radio-controlled
DCF clock
YesNo
Max. number
of measuring
stations
3
Frequency 433 MHz
Range 30 m
Note Weekday
You can choose from German (DE), English (EN), Swedish
(SW), Dutch (DU), Spanish (SP), Italian (IT) or French (FR)
for the weekday display.
Setting the time zone
Note Time zone
•The DCF signal can be received over long distances,
but always transmits the current Central European
Time in Germany. Make sure you account for the time
difference in countries with another time zone.
•If you are in Moscow, the time is 3 hours later than in
Germany. This means that you should set +3 for the
time zone. The clock then automatically sets the time to
3 hours after the DCF signal received or relative to the
manually set time.
Alarm
•In repeatedly press the ALARM ON/OFF button (18) to
display the different alarms. The respective alarm symbols
(12) / / and the corresponding alarm
time/time interval and/or OFF are displayed.
•Press and hold the ALARM ON/OFF button (18) for
approx. 3 seconds to set the alarm time of the alarm
displayed. The hours display/time interval starts to ash.
•Press the button (16) or the button (14) to select
the hour for the alarm time/time interval and conrm your
selection by pressing the ALARM ON/OFF button (18).
The minutes display begins to ash. The early alarm is
already activated after conrming the time interval.
•Repeat the process to set the minutes for the alarm time.
•Press the ALARM ON/OFF button (18) repeatedly to also
set the other alarm mode or return to the time display (10).
•If you do not make an entry for 2 minutes, you
automatically exit the setup mode.
Note Alarm
•When activated, the weekday alarm only triggers an
alarm on weekdays (Monday to Friday). The alarm
symbol (12)
is displayed if this alarm is activated.
•When activated, the once-only alarm only triggers an
alarm once. The alarm symbol (12) is displayed
if this alarm is activated. This alarm is automatically
deactivated after the alarm has sounded.
•When activated and when the outside temperature is <
0°C/ 32°F, the early alarm triggers an alarm 15, 30, 45,
60 or 90 minutes before the actual alarm ( and/or
). The alarm symbol (12) is displayed if this
alarm is activated.
•To determine whether the alarm should be triggered,
the set alarm time is compared to the currently
displayed time (whether normal or time zone-shifted).
•In the corresponding display, press the button (16) or
the button (14) to activate/deactivate the corresponding
alarm.
The alarm symbol (12) will appear/not appear.
Note Early alarm
The early alarm can only be activated if at least one of
the two alarm functions ( / ) has already been
activated.
•If the alarm is triggered, the alarm symbol (12) will begin
to ash and an alarm will sound.
•Press the ALARM ON/OFF button (18) to stop the alarm.
Otherwise, it will stop automatically after 2 minutes.
Otherwise, after two minutes snooze mode is activated
automatically.
Note Snooze function
•While the alarm signal is sounding, press the SNOOZE
button (20) to activate the snooze function. The alarm
symbol (12) begins to ash in the display. The alarm
signal is stopped for 8 minutes, after which it will
sound again.
•The snooze function can be activated three consecutive
times.