Levenhuk strike 120 plus [7/44] Levenhuk strike plus telescopes

5

EN

Levenhuk Strike PLUS Telescopes

EN

1. Remove the contents from the box and identify the parts.

• tripod • red dot nder • counterweight

• accessory tray • eyepieces: 1.25” 25mm, F6.8-F16mm zoom • right ascension slow-motion control

• telescope tube • 2x Barlow lens • declination slow-motion control

2. Adjust the tripod height by loosening the locking knobs, adjusting and leveling the tripod, then retightening the locking

6. Attach the telescope to the mount.

11

7. Attach accessory tray.

8. Loosen the screws of the red dot nder and slide it into the bracket. Tighten locking screws. (Please see further instructions

on red dot nder).

Assembly Instructions

How to use the eyepieces & accessories

It is recommended to follow this order when assembling your telescope for the rst time. It will help you better understand

what each piece does.

1. Focuser

17

Rotate the focus knob away from you until the focus tube goes no further. To focus the view, slowly rotate the focus knobs

toward you until the image is sharp.

Note that the eyepiece has to be inserted otherwise you will not see the image.

2. Eyepiece

The Barlow lens is used to achieve the highest practical power of your telescope. Insert the Barlow lens into the focuser and

then place an eyepiece into the receiving end of your Barlow lens. You will have to refocus the view after this.

1. Remove the red dot nder from the box.

2. Loosen thumbscrews on the side of your nder and slide it into a dovetail mount located at the top of the telescope tube.

3. Tighten thumbscrews.

1. Aim the telescope at an object at least 300 yards away and bring it into focus. This is best done in daylight.

2. Make sure the object is in the center of your view, and tighten all the knobs to prevent any movement.