Kaiser HGE 60301 MW [24/80] Gas cooking zones control

GAS COOKING ZONES CONTROL

Before using your new appliance, we ask you to do

the following:

• Read carefully the operating instructions and

safity conditions.

• Remove the packaging, empty the drawer,

clean the oven cavity in order to eliminate

preservative agents.

• Check up functional efficiency of the stop

valves (installation junction and that of the

cooker) as well as the other control units.

• Heat up the oven (at 250° C for 30 min.)

• Service the cooker only in case of duly

ventilation.

The cooking zones control is achieved by means

of knobs 1, 2, 3 and 4 set up on the control panel

of the cooker.

All gas cookers XL 500 are provided with the

system of electrical ignition operated by means of

knobs.

To switch on a gas burner:

• Press the corresponding knob of the selected

burner against the stop and turn it to the left up

to the position strong gas supply.

• Keep the switch pressed till the burner ignites.

• After the burner has ignited, let the knob go

and select the required flame volume (e.g.

sparing flame).

• To switch off the burner after the food is ready

turn on the knob to the right (position “off”).

If your appliance is provided with gas control

system for the burners and the oven, to ignite a

burner press the knob against the stop and

keep it in the position “strong gas supply” to

activate the control system.

Attention! It is not allowed to adjust gas

supply between the position burner off

and the position strong gas supply