Al-Ko silver comfort 46.4 e 113103 [18/274] Assembly

Al-Ko silver comfort 46.4 e 113103 [18/274] Assembly
en
Assembly
18 469494_a
Do not start the motor if you are standing in
front of the discharge chute.
Start or operate the starter switch with caution
according to the manufacturer instructions.
Observe the local regulations governing the
minimum age of the operator.
Do not operate the device when under the in-
fluence of alcohol, drugs or medication.
Prior to each use, check the unit for damage
and have damaged or worn parts replaced.
Remove foreign objects in the working area.
Keep connecting cables out of the working
area.
Wear suitable work clothing:
Long trousers
Firm and slip-resistant footwear
Ensure that you have a sound footing when
working.
Keep other persons away from dangerous
areas.
Keep body, body parts and clothing away
from the cutter area.
Only work when there is adequate daylight or
artificial lighting.
Always disconnect the plug from the mains
and wait for the unit to come to a standstill:
Whenever you leave the lawn mower
Before you inspect the lawn mower,
clean it or perform work on it
After faults or unusual vibrations occur in
the unit
Before loosening blockages
Before eliminating stoppages
After contact with foreign bodies
ADVICE
After contact with foreign objects inspect
the mower for damage. Perform the ne-
cessary repairs before starting again and
begin working with the lawn mower.
If the lawn mower begins to vibrate strongly
in an unusual way, and immediate inspection
is necessary:
Inspect for any damage
Perform the necessary repair of dama-
ged parts
Tighten all nuts, bolts, and screws firmly
Play special attention when turning the lawn
mower or pulling it towards you.
Do not mow over obstacles (e.g. branches,
roots of trees).
Only remove cuttings when the motor is at a
standstill.
Never lift or carry the unit while the motor is
running.
Never leave the device unattended when it is
ready for operation.
ADVICE
If the mains supply conditions are not
sufficient, brief drops in the mains vol-
tage may occur when the unit is switched
on and this may affect other devices (e.g.
flickering lamps).
For a mains impedance of Zmax < 0.286
Ω these types of interference are not to
be expected.
ASSEMBLY
Observe the enclosed installation instructions.
CAUTION!
The unit must only be operated after it
has been fully assembled
OPERATION
Aıjust the cutting height.
CAUTION!
Risk of injury!
Adjust the cutting height only when motor
is switched off and the cutting blade has
stopped!
ADVICE
Always adjust all wheels to the same cut-
ting height.
Cutting height adjustment depends on
the model.
Axle aıjustment or central aıjustment
ADVICE
Always adjust both axles to the same
cutting height.
1. To unlock, press the lever to the side and
hold. (1)
For a short lawn, slide the lever in the di-
rection of the front wheel.
For a longer lawn, slide the lever in the
direction of the rear wheel.
2. Allow the lever to engage.

Содержание

Скачать