Instrumax sniper 50 plus im0116 Инструкция по эксплуатации онлайн [5/48] 195094

rear is set.

You will see the reference symbol on the display.

Selecting Units

Press and hold the button (6) for 2 sec. until the desired unit

is displayed.

Illumination

Press and hold the button (1) for 2 seconds to switch the

illumination on or off.

Clear-Key

Cancel the last action. Press button (7).

MEASUREMENTS

Single distance measurement

Press button (4) to activate the laser. When in continuous laser

mode, press this button to trigger the distance measurement

directly.

Press again to trigger the distance measurement. The result

is displayed immediately.

Continuous Measurement

Press and hold the button (4) for about 2 seconds to start con-

tinuous measuring.

Minimum/ Maximum measurement

This function allows the user to measure the minimum or max-

imum distance from a xed measuring point. It is commonly

used to measure room diagonals (maximum values) or hori-

zontal distances (minimum values).

Press and hold down the button (4). Then slowly sweep the

laser back and forth and up and down over the desired target

point-(e.g. into the corner of a room).

Press to stop continuous measurement. The values for maxi-

mum and minimum distances are shown on the display as well

as the last measured value in the summary line.

FUNCTIONS

Addition / Subtraction

Measure the distance. Press button (2): next measurement is

added to the previous one. Press button (6): next measure-