Tohatsu MFS 25 — инструкция по настройке и проверке управления трансмиссией [71/319]

Превью страниц Страница 71 / 319

3-23

25/30 2006

16. Reconnect cord ass'y connectors.

CAUTION

Do not disconnect cord ass'y while engine

operates.

17. Run cord ass'y a and remote control cables s through

grommet p located on the front of bottom cowl. Attach

remote control cable groove to bracket, and then fix it to

bottom cowl.

18)

Inspection of Shift Lever Gear Operations

Shift gear from neutral (N) to forward (F), neutral (N), and

then to reverse (R) to check that shift operation is performed

smoothly. Adjust shift link rod 1 length and shift cable

position if necessary.

1. Shift gear into neutral (N).

2. Remove shift link rod 1.

3. Check and adjust standard length a of shift link rod 1.

4. Check that shift lever shaft 3 and shift arm 2 are vertical.

Remote control model a : 52 mm ( 2.05 in )

Tiller handle model a : 144.5 mm ( 5.69 in )

5. Perform shift adjustment after assembling lower unit.

(Tiller Handle Model)

Remark: The adjustment is difficult when power head has been

installed.

Loosen shift lever stopper bolt 4.

Set shift lever shaft ass'y 5 fully to forward, adjust shift lever

stopper 6 position, and then, tighten shift lever stopper bolt 4.

Sep

arate shift lever to check that operation from neutral (N)

to forward (F) to neutral (N) to reverse (R) is normal and

forward and reverse movements are equal to each other.

a Oval Hole

MFS25_30_ch03.qxd 06.3.9 4:33 PM ページ 23