Antec LanBoy Air Blue [9/27] Note the order in which hardware is installed in this manual is different from that of typical cases this is

2.1 S

ETTING

1. Put the chassis upright on a flat, stable surface so that the rear panel

(power supply and expansion slots) is facing you. Remove the

thumbscrews as depicted in Figure 1 on the right, and remove the

corresponding thumbscrews from the other side.

2. Remove the larger panels by pulling them away from the chassis.

3. Remove the smaller panels by rotating them outward slightly less than

180º (Figure 2), and pulling them off their hinges, starting with the

bottom hinge.

4. The LanBoy Air should now look like Figure 3.

Note: The order in which hardware is installed in this manual is different from that of typical cases; this is

due to the unique design of the LanBoy Air chassis. We recommend that you follow the order laid

out in this manual, as it takes full advantage of the LanBoy Air’s features.

Figure 1 – Side panel thumbscrews

Figure 2 – Rotate smaller panels to

remove

Figure 2 – Rotate smaller panels

outward

and remove the bottom hinge first

Figure 3 – LanBoy Air with side panels

removed