Antec LanBoy Air Blue [16/27] Caution make sure to remove any unused motherboard standoffs they may come into contact with the

1. With the motherboard tray on a flat surface, lay the motherboard on the tray and align it with the standoff

holes on the motherboard tray and remember or mark which holes are lined up (Figure 23).

2. Now remove your motherboard by lifting it up.

3. Install standoffs as needed (Figure 24) and put the motherboard back in.

4. Screw in your motherboard to the standoffs with the provided motherboard mounting screws (Figure 25).

Caution: Make sure to remove any unused motherboard standoffs. They may come into contact with the

back of the motherboard and may electrify your chassis exterior if left connected.

Note:

This section assumes

that you have removed the motherboard tray in section 2.5. If you are

installing a motherboard directly into the chassis, lay the chassis on its side with the drive mounts on the

right.

Figure 23 – Motherboard tray with motherboard

Figure 24 – Motherboard tray with preinstalled standoffs and additional

standoff holes i

dentified

Figure 25 – Screwing in the motherboard after standoffs are installed